Operating The Appliance - VINCENT SV-129 Manuel D'utilisation

Operation
Switch on and off
Select an input
Change the volume
Mute the speakers and
the preamplifier output
Change height
proportions of the
sound
Change the bass
proportions of the
sound

OPERATING THE APPLIANCE

Button(s) Description
The device is switched on and off at the front side. If the switch is in the off
position, the device is disconnected from the mains. The device does not
possess any function of the operating state (standby). In switched on-mode
POWER (1)
the lights shines on the power switch LED. Before turning on as a precauti-
on the volume of the precursor (7) (17) should be reduced.
The input selection can only be made on the front panel. The knob
"INPUT" has four notches for the four input sources at the ports "TUNER",
"DVD", "AUX" and "CD". By turning the knob, the desired source can be
INPUT (9)
selected.
TAPE (8)
Before switching over the input channel, the volume (7)(17) should be tur-
ned down as a precaution!
On device: Turn the knob "VOLUME" clockwise to increase the volume and
counter clockwise to decrease the volume.
On the remote: Hold the button "VOL
VOLUME (7)
increase. Use "VOL
VOL /
attached in the volume button shines.
(17)
The volume control affects the signal of the speaker and the output "PRE
OUT" (12). The output signal of "REC OUT" (11) remains unaffected.
The mute button only works with the remote control key. It turns off the loud-
speaker and the signal from the preamp "PRE OUT" (12). While the device is
MUTE (16)
muted, the LED flashes on the power switch. Pressing again will restore the
volume. The output signal of "REC OUT" (11) remains unaffected.
With the knob "TREBLE" at the front, you affect the proportion of the higher
tones of the sound image. Clockwise rotation increases the intensity set,
moving counter clockwise reduces the intensity. The setting is only effective
TREBLE (3)
if the "TONE" button (6) is pressed. The tone control affects the signal of
the speaker and the output "PRE OUT" (12). The output signal of "REC
OUT" (11) remains unaffected.
With the knob "BASS" on the front, affect the proportion of the deeper
tones of the sound image. Clockwise rotation increases the intensity set,
moving counter clockwise reduces the intensity. The setting is only effective
BASS (4)
if the "TONE" button (6) is pressed. The tone control affects the signal of
the speaker and the output "PRE OUT" (12). The output signal of "OUT
REC" (11) remains unaffected.
" button to adjust the volume to
" to reduce it. While the volume is adjusted, the LED
Vincent
37