Operating The Appliance - VINCENT KHV-200 Manuel D'utilisation

CONNECTION OF THE POWER CABLE
Check that the electricity supply to your home is appropriate to the device. The required voltage and
frequency can be read on the back of the device beside the socket for the mains. If the electricity supply is
appropriate, push the inlet connector of the supplied mains cable firmly into socket for the mains on the
back of the device (16). Connect the other end of the mains cable to a mains socket.
Operation
Switch on and off
Change the volume
Select an input
Change brightness set-
ting of the tube window

OPERATING THE APPLIANCE

Button(s) Description
The amplifier is switched on and off using this button at the front
panel, there is no standby option. When switched off the device is
internally separated from the AC power. As a precaution, before
POWER (3)
switching on, the volume setting (2) should be reduced. After switching
on, the LED (3) on the front panel flashes and the appliance needs
about 30 seconds, in the process of warming up the tubes, before it is
ready to operate. This is the case if the volume LED is constantly lit.
Turn the knob "VOLUME" clockwise to turn up the volume and
VOLUME (6)
counterclockwise to turn it down.
Press the "INPUT" button on the front panel to toggle between the
input sources connected to the inputs "CD" and "AUX".
INPUT (5)
Before switching over the input channel, the volume (2) should be
turned down as a precaution!
The tube window (1) can be illuminated at three brightness levels.
The selector switch "LAMP" allows setting these levels as well as
DIMMER (13) deactivating the light. Set the switch to its position "OFF" to turn off
the light. Set the switch to its position "1" for a low light intensity
and "3" for maximum light intensity.
31