VINCENT SV-129 Manuel D'utilisation page 34

CONNECTION OF TWO ADDITIONAL AMPLIFIER CHANNELS
The jack "PRE OUT" (11) is only needed when you separate amplifier for the supply of additional spea-
kers want. This can be useful when two more speakers will be used for stereo music playback, even in
another room. These speakers are then connected to the outputs of respective amplifiers. The output con-
nectors "PRE OUT" (12) of SV-129 are connected with the input terminals of the amplifier (s), which are
mostly labelled as "INPUT", "POWER AMP IN" or "MAIN INPUT".
SV129
As shown here, instead of stereo power amplifier, two mono amplifiers can also be used.
CONNECTION OF THE LOUDSPEAKERS
On the SV-129 amplifier, a pair of speakers can be connected. For each speaker you will find two spea-
kers at the device terminals (positive + and negative -), with one side of a speaker cable connected. At
each terminal pair you will find a label (R or L), which indicates to which side (right or left), the terminal
pair belongs. On speakers, there are like or similar connections, marked here also, which connect to the
pole (+ or -) belongs to. Here is the other end of the assigned speaker cable. The speaker cables must be
connected like ports on a terminal pair: marked with "+" terminal on the amplifier must be marked with
a "+" connector of the speaker lead.
SV129
Vincent
34
RCA connection
MAIN IN
Speaker cable
Amplifier