VINCENT SV-129 Manuel D'utilisation page 36

CONNECTION OF THE LOUDSPEAKERS
If a loudspeaker is to be connected with "bi-wiring", both pairs of loudspeaker clamps may be used at
the same time. In contrast to connection of the loudspeakers with one loudspeaker cable each, with bi-
wiring a suitable loudspeaker is connected via two separate two-wire loudspeaker cables or one four-
wire loudspeaker cable to the pair of output clamps on the main amplifier. This doubles the cabling
R
Rückseite Rückseite
des rechten des linken
Lautsprechers Lautsprechers
CONNECTION OF THE POWER CABLE
Check whether the wall socket provides the appropriate mains power, which is the case if it is supplied
with 230 V AC 50 Hz. Push the plug on the power cable supplied firmly into the power socket (15) on
the back of the appliance. Plug the other end of the power cable into a mains socket.
Vincent
36
required but for many combinations of loudspeakers and amplifiers
this improves the sound quality.
L
Before changing the system to bi-wiring, the metal bridges fitted to the
loudspeaker's double connector in normal operation must be removed.
Only loudspeakers with these bi-wiring terminals are suitable. Filtering
of the entire frequency range occurs in the now separated loudspeaker
crossover networks. One cable is to be connected to the loudspeaker's
sockets provided for the higher frequencies (treble) and the other with
the ones for the lower frequencies (bass) for each loudspeaker. Make
sure that the polarity is correct. Your specialist dealer will provide you
with advice and assistance.