Operating The Appliance; Button(S) Description - VINCENT SP-996 Manuel D'utilisation

Operation
Switch on and off
Activate or deactivate
audio signal dependent
auto-shutoff
Vincent
30

OPERATING THE APPLIANCE

Button(s) Description
The amplifier is switched on and back to standby using this button at the
front panel. When switched off the device is not internally separated from
the AC power and reacts to a signal at one of the inputs "POWER CON-
TROL" (6). This main amplifier can not be switched on or off by means of
the "POWER" button as long as a cable is plugged into the "POWER
POWER (1)
CONTROL" (6) sockets. As a precaution, before switching on, the volume
setting of the preamplifier should be reduced. After switching on, the LED
located at the front panel flashes for about five seconds while the pream-
plifier's protective circuit is active and muting the output. The LED is lit per-
manently as long as the amplifier is active.
With this switch you can activate or deactivate the automatic-shutoff functi-
on. When set to "ON" it makes this main amplifier switch back into stand-
AUTO (5) by automatically 30 minutes after a signal has been detected for the last
time at the socket "LINE IN" (3). This function is not effective in case of a
connected Power Control Cable (6).