Removing The Bathlift From The Bathtub - Aquatec Beluga Mode D'emploi

2. Fold the sideflaps of the seat outwards (fig. 8).
3. Place the backrest (without the battery) (3, fig. 9)
onto the seat so that the slots (4, fig. 9) in the
backrest fit in the hinges (6, fig. 9) of the seat
plate (5, fig. 9).
4. Press the spindle (1, fig. 9) into the spindle catch
(2, fig. 9) until it is engaged.
CAUTION!
There is a risk of damage if the spindle foot
slips out.
●
Before you lift up the backrest, check
that the spindle is pushed into the catch.
●
After you have folded the backrest out,
check that the spindle foot is in the spin-
dle foot retainer and is locked.
5. Carefully lift the backrest by pulling it up at the
head end (fig. 9).
The pegs on the clamp ring (4, fig. 10) fit in the guides
(6, fig. 10) on the seat plate. The spindle (2, fig. 10) is
released from the catch (1, fig. 10). The spindle foot (5,
fig. 10) is in the spindle foot retainer of the base plate.
The ratchet (3, fig. 4) locks the spindle foot.
6. Insert the charged battery (2, fig. 11) into the
guide (3, fig. 11) in the backrest from above.
7. Push the battery down completely.
The battery should click in.
The bathlift is now ready for use.
5.4

Removing the bathlift from the bathtub

1. Let the water out of the bath.
2. Lower the bathlift (1, fig. 12) by pressing the
DOWN button (5, fig. 13), until the backrest is at
the stop.
Important!
Grasp deep into the grip so that you can hold
the battery safely.
3. Unlock the battery by pulling the grip (1, fig. 11) up
slightly.
4. Pull the battery upwards out of the guide (2,
fig. 12).
7
Important!
● When folding the backrest, ensure that the
curled cable of the hand control does not
get caught.
●
Do not fold the backrest down if there is wa-
ter in the bath.
5. Hold the head end of the backrest in one hand.
6. With your other hand, hold the spindle near the
red spot (3, fig. 10).
7. Push the spindle forward and at the same time
slowly fold the backrest all the way forward (3,
fig. 12).
8. Press the spindle into the catch (2, fig. 9).
Important!
When lifting, please remember: The seat
weighs 8.6 kg, and the backrest weighs 4.3 kg
(without the battery).
9. Pull the backrest up off the seat (4, fig. 12) and out
of the bath tub.
10. Fold the sideflaps on the seat inwards (5, fig. 12).
Important!
Release the suction cups at the rear simulta-
neously.
11. To release the rear suction cups, pull the straps
(11, fig. 1).
12. Lift the rear end of the seat further (6, fig. 12). This
releases the front suction cups.
Important!
If you have installed the height adapters (op-
tional), you also have to pull the straps on the
front suction cups to release them.
13. Take the seat out of the bath.
14. Carefully put away all components of the bathlift.
EN