Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
5.2
Attaching the suction cups
CAUTION!
There is a risk of injury when the lifting scis-
sors move.
Do not reach between the lifting scissors
during assembly.
Important!
To detach the suction cups, follow these in-
structions in reverse order.
5.2.1
Preparing for assembly
1.
Place the seat on its side.
2.
Press the red button (1, fig. 4) in the spindle foot
retainer (2, fig. 4).
The locking mechanism between the base plate and
seat plate opens.
3.
Carefully pull the base plate (8, fig. 1) and the seat
plate (2, fig. 1) apart.
The seat is now lying in a stable position on its side.
5.2.2
Attaching the front suction cups
Important!
●
The procedure is the same for the right and
the left sides.
●
The front suction cups have only one strap
and a head that can be inserted into the
plate.
1.
Press the red suction cup lid (2, fig. 5) from below
out of the slotted hole (3, fig. 5) in the base plate.
Important!
Lubricant film facilitates assembly.
2.
Apply a thin layer of commercial skin cream to the
head of the suction cup (4, fig. 5).
Important!
The strap with the toggle must point back-
wards when you insert it.
3.
Insert the suction cup head from the bottom into
the large opening in the slotted hole.
4.
Pull the suction cup head all the way to the front of
the smaller opening of the slotted hole.
5.
Bend up the strap (5, fig. 5) and hook the toggle
into the groove (1, fig. 5).
6.
Push the red suction cup lid back in.
EN
5.2.3
Attaching the rear suction cups
Screw the suction cup (1, fig. 6) from below into the
threaded liner (2, fig. 6) provided for this.
Important!
●
The procedure is the same for the right and
the left sides.
●
The rear suction cups have two straps and
a thread.
●
Attach the suction cups in such a way that
you can reach one strap of each suction
cup when the lift is set up in the bath.
The threaded liner is located on the same side of the
base plate (3, fig. 6) as the spindle foot retainer (4,
fig. 6).
5.2.4
Completing assembly
1.
Carefully push the lifting scissors back together.
The locking mechanism between the base plate and
seat plate closes automatically.
2.
Place the seat on the attached suction cups.
5.3
Setting up the bathlift in the bathtub
CAUTION!
The seat may slip if the suction cups do not
adhere properly.
●
Before you set up the bathlift, clean the
bathtub and the suction cups.
●
Do not move the bathlift once you have
installed it in the bathtub.
Important!
●
The suction cups have to be attached.
●
The battery must be fully charged.
●
When lifting, please remember: The seat
weighs 8.6 kg and the backrest weighs
4.3 kg (without the battery).
●
If your bath has a handrail, use the sideflap
diverter (optional).
1.
Place the seat (2, fig. 7) onto the base of the emp-
ty bathtub. The spindle foot retainer (3, fig. 7)
must point towards the end of the bath opposite
the drain (1, fig. 7).
6
Publicité
Chapitres
Table des Matières
