Troubleshooting; Care And Maintenance; Seat And Backrest; Charger And Battery - Aquatec Beluga Mode D'emploi

6.3

Troubleshooting

Important!
The following table provides information on
faults and their probable cause. If you cannot
rectify a fault using the table, please contact
your authorised dealer directly.
Problem Possible
causes
No motor noise/ The battery is not
bathlift does not properly inserted
move
The battery is flat
The contacts are
dirty
The cable is dam-
aged
The bathlift can be Low-voltage pro-
raised but not low- tection is activated
ered
The bathlift stops The load is exces-
while being raised sive
The battery can- The fuse is faulty
not be recharged
The battery is
faulty
The bathlift slips The suction cups
are old or dam-
aged
7

Care and maintenance

7.1

Seat and backrest

CAUTION!
There is a risk of injury when the lifting scis-
sors move.
Be especially careful when cleaning the
seat.
There is a risk of damage.
Never clean the backrest with a high pres-
sure cleaner.
Important!
●
Regularly clean the seat and backrest and
keep them clean.
●
Do not use abrasive cleaning agents.
1. Wash the product with commercial detergents and
disinfectants using a cloth or brush.
2. Rinse the product with warm water.
9
Remedy
Insert the battery
(see section 5.3)
Recharge the bat-
tery (see
section 5.1)
Clean the contacts
Have your author-
ised dealer re-
place the cable
Recharge the bat-
tery
Note max. load
Have your author-
ised dealer check
the battery
Replace the bat-
tery
Replace the suc-
tion cups
3. Dry the product with a cloth.
4. Lightly grease the track (6, fig. 1) using Vaseline.
5. Remove the covers (optional) from the seat and
backrest.
CAUTION!
There is a risk of damage.
Do not tumble-dry the covers (optional).
6. Wash the covers (optional) in the washing ma-
chine at maximum 60 °C using a mild detergent.
7.2

Charger and battery

CAUTION!
There is a risk of injury from electric shock.
●
Before cleaning the charger, always pull
the plug out of the power socket.
●
Never plug objects made of conducting
material (e.g. knitting needles, metal
pins) into the battery socket.
● Only use a dry cloth to clean the charger
and the battery.
Wipe down the charger and the battery with a dry
cloth.
7.3

Maintenance

The bathlift is maintenance-free provided you follow
the care instructions described above.
EN