Transport; Troubleshooting Table - Güde GDS 16 PRO Traduction Du Mode D'emploi D'origine

Cleaning
Keep the protective equipment, ventilation slots and
•
engine covers with no dust and dirt if possible. Wipe
the appliance with a dry cloth or blow it with
compressed air at low pressure.
The appliance is recommended to be cleaned
•
immediately after being used.
Clean the appliance regularly with a wet cloth and a
•
bit of soft soap. Do not use any cleaners and solvents
as they could damage the plastic parts of the
appliance. Make sure no water gets in the inside of
the appliance.
Carbon brushes
Have the carbon brushes checked by an electrician when
sparks are produced excessively.
Caution! Carbon brushes may only be replaced by an
electrician.
Servicing
There are no other parts inside the appliance requiring
servicing.

Transport

The appliance must cool down before being transported.
Troubleshooting
The table shows possible failures, their causes and
remedy options. If the problem still cannot be removed,
contact a professional to help you.
Switch the appliance off and unplug it before any
servicing and cleaning.
Risk of electric shock.

Troubleshooting table

Symptoms Possible cause
Saw blade is too thin for
•
the processed material
Too much pressure on the
•
saw blade
Saw blade is
broken
Saw blade is too
•
stretched
Curve cut is too narrow
•
Saw blade is too loose
•
Saw blade is Saw blade has been
•
not cutting subject to too intensive
straight, it is side loading
turned Saw blade getting
•
warm/workpiece is too
thick.
Saw has been overloaded
•
by the workpiece
Saw blade is worn out
•
Engine
slowing
Chippings have blocked
down and
•
the exhaust flue
remaining
standing
Dust Produced as a result of
•
accumulatin standard work
g in the
appliance
Laser or Laser or LED lamp are
•
LED lamp defective
not working
15
Remedy
Fit a thicker saw
•
blade
Move the
•
workpiece
continuously with
even, however,
not too much
pressure on the
saw blade. Let
the saw work by
itself.
Reduce the saw
•
blade tension
Bigger radius or
•
narrower saw
blade
Increase the saw
•
blade tension
Replace the saw
•
blade
Use a straight
•
saw or thinner
material
Opt for higher
•
revolutions; do
not apply too
much pressure
on the saw blade
Replace the saw
•
blade
Remove any
•
chippings from
the cover.
Connect the
exhaust
equipment or
increase the
exhaust
equipment output
Clean the
•
appliance at
regular intervals
Replace the laser
•
or LED lamp