BORETTI BRVA88 Notice D'emploi page 66

GB
Installation
Take utmost care when handling
your appliance so as not to
cause any damages to the cooling
unit with consequent possible fluid
leakages.
During normal
condenser and compressor at the
back of the appliance heat up
considerably. Always ensure that there
is adequate ventilation as a failure to
do this will result in component failure
and possible
installation instructions.
Important: if the supply cord is
damaged, it must be replaced by a
special cord or assembly available
from the manufacturer or its service
agent.
Positioning
Unpack the cabinet and check that it
is in good condition and free of any
transport damage.
The appliance must not be located
close to radiators or gas cookers.
Avoid prolonged exposure of the
appliance to direct sunlight.
For safety
ventilation must be as shown in Fig.
Attention: keep ventilation openings
clear of obstruction.
It is necessary that the niche is
provided with a conduct of venti-lation
having the following dimensions:
Depth: 50 mm
Width: 540 mm
66
operation,
food loss.
reasons, minimum
the
See
The climate classification can be found
on the rating plate, which is located
inside the cabinet on the left hand wall.
The following table shows which ambient
temperature is correct for each climate
classification:
Climate
classification
SN
N
ST
T
Electrical connection
Before plugging in, ensure that the
voltage and frequency shown on the
serial number plate correspond to your
domestic power supply.
Voltage can vary by ±6% of the rated
voltage.
For operation with different voltages, a
suitably sized auto-transformer must be
used.
Important
The appliance must be earthed.
The power supply cable plug is provided
with a contact for this purpose.
If the domestic power supply socket is
not earthed. connect the appliance to a
separate earth in compliance with current
for an ambient
temperature of
+10 to +32 °C
+16 to +32 °C
+16 to +38 °C
+16 to +43 °C