Stihl MSA 160 C Notice D'emploi page 24

English
Hold the filler cap down and twist it
N
clockwise until it engages
Then the markings on filler cap and oil
tank will align
Close cliplock
N
22
Filler cap is locked
If the filler cap will not lock onto the oil
tank
The base of the filler cap is tilted in
relation to the upper part.
Remove the filler cap from the oil
N
tank and look at it from above
1
Left: Base of filler cap is tilted –
interior marking (1) is aligned
with the exterior marking
Right: Base of filler cap is in the cor-
rect position – interior
marking is below the clip. It
does not align with the exte-
rior marking
Fit filler cap and twist it
N
counterclockwise until it engages in
the seat of the filling port
Continue to twist the filler cap
N
counterclockwise (approx. 1/4 turn)
– this will twist the base of the cap
into the correct position
Twist the filler cap clockwise and
N
close it – see section "Closing"
MSA 160 C, MSA 200 C