Tensioning The Saw Chain (Quick Chain Tensioner); Checking Chain Tension; Chain Lubricant - Stihl MSA 160 C Notice D'emploi

English
Tensioning the Saw Chain
(quick chain tensioner)
1
2
For retensioning during operation:
Remove the battery from the
N
machine
Fold out the wings of the wing nut
N
and loosen the wing nut
Turn the adjusting wheel (1) to the
N
right as far as possible
Tighten the wing nut (2) by hand
N
Fold in the wings of the wing nut
N
Next step: Continue with "Check
N
chain tension"
A new saw chain must be retensioned
more frequently than one that has been
in use already for an extended period!
Check chain tension frequently –
N
see "Operating Instructions"
20

Checking Chain Tension

Remove the battery from the
N
machine
Put on protective gloves
N
Pull hand guard towards the front
N
handle until it engages audibly and
the hand guard is in the position ‚
– chain brake is released
The saw chain must lie against the
N
bottom of the bar and it must be
possible to pull it across the guide
bar by hand
if necessary, retension saw chain
N
A new saw chain must be retensioned
more frequently than one that has been
in use already for an extended period.
Check chain tension frequently, see
N
"Operating Instructions"

Chain Lubricant

For automatic and reliable lubrication of
the chain and guide bar – use only an
environmentally compatible quality
chain and bar lubricant. Rapidly
biodegradable STIHL BioPlus is
recommended.
NOTICE
Biological chain oil must be resistant to
aging (e.g. STIHL BioPlus), since it will
otherwise quickly turn to resin. This
results in hard deposits that are difficult
to remove, especially in the area of the
chain drive and chain. It may even cause
the oil pump to seize.
The service life of the chain and guide
bar depends on the quality of the
lubricant. It is therefore essential to use
only a specially formulated chain
lubricant.
WARNING
Do not use waste oil. Renewed contact
with waste oil can cause skin cancer.
Moreover, waste oil is environmentally
harmful.
NOTICE
Waste oil does not have the necessary
lubricating properties and is unsuitable
for chain lubrication.
MSA 160 C, MSA 200 C