Lcd/Crt/Tv Display; Resolutions And Colors - MAXDATA 400M Guide D'utilisation

The LCD Screen

5.2 LCD/CRT/TV Display

By pressing and holding down the Function key couple <Fn> <F2> together, you can
switch your display between: LCD only , CRT only, and LCD/CRT simultaneous. By
pressing and holding down the Function key couple <Fn> <F6> together, you can switch
your display between LCD and TV.
Note:
When you switch your display from CRT Only to LCD/CRT (simul), the
following symptoms may occur:
- Depends on your CRT, the size of the screen may be different from
- The displayed screen is off-centered.
- The screen flickers.
The symptoms are caused by the lower CRT refresh rate when simul display
is selected. This problem is usually more severe in DSTN than in TFT. If you
want a better display, you should select CRT Only.

5.3 Resolutions and Colors

TFT:
Depending on the different drivers under Windows, DOS or other operating systems; you
can have different resolutions with different fonts and colors. For more information on
Display Modes, run the utility software supplied with your notebook. See Chapter 10,
for installation procedure.
CRT:
The resolutions on the CRT depends on both the CRT and its driver program. The VGA
driver supplied can display up to 1024x768 (non-interlaced) under the Windows
environment.
Note:
To get the fastest speed and most colors under Windows, you need to
install the VGA drivers that comes along with your notebook. For more
information on how to install the drivers, see Chapter 10.
Page 5-2
(smaller/larger than) the size CRT displayable area.
Information in this document is subject to change without notice!!!
Model 400M & 700T User's Manual