Default Factory Setting; Camera Data; Saved Files; Firmware Version - Minox DTC 700 Mode D'emploi

Default factory setting

With this, you can restore your DTC 700 settings
to factory settings. Go to the "Main Menu" by
pressing the menu button (8) and select the menu
option "Default Settings". This is located under the
second tab "General Settings". Press the OK but­
ton (9) or the right arrow button (10) to access the
submenu. You can select "Yes" or "No" using the
Up/Down arrow keys (10) and confirm with OK (9).
Select "No" to retain the existing settings and the
camera will return to the previous menu selection.
If you choose "Yes", your DTC 700 shall be restored
to the factory settings and revert to the second tab
"General Settings" in the "Main Menu".

Camera data

Go to the "Main Menu" by pressing the menu
button (8) and select the menu option "Camera
info". This is located under the second tab "General
Settings". You can access the submenu by pressing
the OK button (9) or the right arrow key (10). In
the submenu, you can use the Up/Down arrow key
(10) and select from the following data stored in
your camera; Saved files, memory space, firmware
version.

Saved files

Go to the submenu on the menu option "Saved fi­
les" and press the OK button (9) or the right arrow
key (10). After that, the actual number of photo and
video files will be displayed. Confirm using the OK
button (9) or the left arrow key (10) to return to
the Start Menu.
Memory space
Go to the menu option "Memory" in the submenu
and press the OK button (9) or the right arrow key
(10). Subsequently, "Used memory space" and
"free memory space" will be indicated. Press the
OK button (9) or the left arrow key (10) to confirm
and return to the Start menu.

Firmware Version

Go to the menu option "Firmware Version" in the
submenu and press the OK button (9) or the right
arrow key (10). You will then be shown the current
Firmware Version. Confirm with OK (9) or using the
left arrow key (10) to return to the Start menu.
36

Software updates

If an update is available for your DTC 700, plea­
se proceed as follows: Make sure your DTC 700 is
switched off ("OFF" function: Main Switch (11), lo­
wer position). Copy all the files needed for updating
directly onto a formatted SD card. Insert the SD card
into your DTC 700 as 33 described in the section
"Using the memory card". Bring your camera into
the "SETUP" mode (Main Switch (11), centre). Go
to the Main Menu by pressing the menu button
(8) and select the menu option "Updates". This
is located under the tab "General Settings". Press
the OK button (9) to access the submenu. Using
the Up/Down arrow keys, you can select "Yes" or
"No" and confirm with OK. Select "No" to retain
the existing software version and the camera will
return to the previous menu selection. If you select
"Yes", your DTC 700 will begin installing the up­
dates. The update installation is completed once
your camera screen turns black. Please switch your
DTC 700 now to "OFF" function: Main Switch, lo­
wer position. When you switch on the camera the
next time in the "SETUP" mode, Main Switch (11),
centre, the new software is ready for use. Press the
left arrow key (10) to return to the previous menu
without installing the updates.
Note: Choose alkaline if using lithium batteries.
Press the OK button (9) to save the settings. The
camera will automatically return to the Start menu.
You will return to the previous menu without any
changes to the settings by pressing the left arrow
key (10).