WOHLHAUPTER DIGIBORE 501 Mode D'emploi page 14

English
Fig. 8
Fig. 9
Clamping (Fig. 10)
The tool is provided with a clamping
screw ①. Secure the slide with the
clamping screw to ensure that no chang­
es in diameter can occur (tightening
torque 8 Nm (70.81 in. lbs.)).
During machining, the slide must be
secured with this clamping screw. This
clamping must be applied before and
after every adjustment procedure
③
Fig. 10
Caution:
Do not adjust the diameter
when the slide is clamped!
Otherwise the adjustment
parts will be damaged.
14
①
②
Diameter adjustment (Fig. 10)
This precision tool has an electronic
traverse measuring system with a digital
display.
Comply with the following sequence
when adjusting the diameter (Fig. 10):
1. Switch on the digital display by press­
ing the "ON/Reset" button. The display
will then show the last dimensional
reading. This will switch off automati­
cally 30 seconds after you have com­
pleted the adjustment procedure. Max.
ON time is 120 seconds.
2. Slacken the clamping screw ①.
3. Adjust the boring range with adjuster
screw ② using a hexagon wrench SW
4 and at the same time read off the
display. The real adjusted range in
diameter at the slide or cutting edge is
shown.
Please note the following points: no
sign = increase in diameter, minus sign
(­) = reduction in diameter.
4. Tighten clamping screw ① (tightening
torque 8 Nm (70.81 in. lbs.))
Remarks:
• When the display is switched on, it can
be reset to "0" by pressing the "ON/
Reset" button again.
• The display always shows the dimen­
sional change from the previously set
value or 0. The absolute slide position
cannot be shown.
Caution:
Make dimensional corrections
to the precision tool only
with the electronic system
switched on. Noncompliance with this
requirement will result in an undefined
cutting edge position and the precision
tool will have to be readjusted with a
setting instrument.