Before Use; Massage Direction - SOLAC ME7711 Mode D'emploi

 BODY-MODELLING (11): "Smooth roller"
head, effective treatment on painful cellulite
 DRY BRUSH (9): Exfoliating brush, removes
dead skin and stimulates blood flow.
 BALL MASSAGE HEAD (12): Stimulates and
tones the muscles, helping to firm the skin. It
improves circulation in the abdominal area,
eliminating localised toxins and improving the
intestinal tract, preventing constipation.
INSTRUCTIONS FOR USE
GENERAL RECOMMENDATIONS FOR USE:
 The intensity control allows you to regulate the
intensity of the massage as required. Start with
a gentle speed and progressively increase
depending on your sensitivity to the massage.
 The red light is an additional massage function.
Use it to strengthen the effectiveness of the
massage.
 If you use specific treatment creams (toning or
anti-cellulite) apply these after the massage.
 The appliance is equipped with a motor
protection system that switches the motor off if
it overheats. If this occurs, leave the appliance
to cool down before attempting to restart it.
 If you wish to continue using the appliance,
allow it to cool down before proceeding.
 For a more effective treatment, use the
appliance regularly. Use the appliance each
day until you notice the results, you can then
use it to maintain these results. To maintain the
results over the long-term, adapt your lifestyle
habits and food.

BEFORE USE:

 Make sure that all the product's packaging has
been removed.
USE:
 Unroll the cable completely before plugging it
in.
 Connect the appliance to the mains.
 Turn the appliance on using the on/off switch.
 Select the desired speed.
 Choose a massage head
 You may alternate the use of different heads
during the same massage.
 Set the intensity of the massage using the
intensity control (3) and place the massager on
the area on which you are going to work.
 Use the massage controller to set the intensity,
using your finger to turn the controller (3) one
way or the other depending on the desired
setting (Fig. 4)
 Move the switch (2) to the massage position
(Fig.2 B) or to the "massage + infrared position
(IR) position" (Fig.2 C) according to the desired
treatment.
 Fit the head corresponding to the desired
treatment onto the head adaptor (Fig. 3)
 Hold the appliance firmly with both hands and
move it over the skin in the direction of the
blood circulation (see "Massage Direction").
 Without pressing too hard, simply glide the
massager over the area to be treated. Pressing
the appliance too hard against the skin will
prevent the motor from operating efficiently.

MASSAGE DIRECTION:

 Always glide the appliance over the skin in the
direction of the blood circulation. In an upward
direction.
 NEVER directly massage the spine.
 NEVER directly massage a bone (knee, ankle,
elbow). The protruding parts of the massage
head could hit the bone, causing an injury.
 Legs: Place the appliance on the thigh, close to
the knee, and glide it gently upwards towards
the hip (Fig. 5)
 Buttocks: Combine upward and circular
movements. (Fig. 6)
 Abdomen: Place the appliance on the navel
and move it gently outwards (Fig 7). Never
make circular movements around the navel.
 Arms: Place the appliance close to the elbow
and glide it gently towards the armpit. Repeat
the massage from the armpit towards the elbow
(Fig. 8)
 Back: Place the appliance in the area of the
spine and glide it gently upwards towards the
shoulder blade (fig. 9)
CHOOSING A MASSAGE HEAD:
1 SKIN PREPARATION
 It is essential to start by preparing the skin
properly before performing the massage in the
area where it is required, so we should
exfoliate the skin using the natural bristle brush
10
EN