Recommended Oil; Oil Level Check; Oil Change; Reduction Case Oil - Honda GX270 Manuel De L'utilisateur

3RZ7E6000.fm 9 ページ ２０１２年１１月２０日 火曜日 午後２時３９分

Oil Level Check

Check the engine oil level with the engine stopped and in a level
position.
1. Remove the oil filler cap.
2. Check the oil level. If it is below the upper limit, fill with the
recommended oil to the upper limit (see page 8).
3. Reinstall the oil filler cap securely.
OIL FILLER CAP
Running the engine with a low oil level can cause engine damage.
This type of damage is not covered under the Warranty.
The Oil Alert system (applicable types) will automatically stop the
engine before the oil level falls below the safe limit. However, to
avoid the inconvenience of an unexpected shutdown, always check
the engine oil level before startup.

Oil Change

Drain the used oil when the engine is warm. Warm oil drains
quickly and completely.
1. Place a suitable container below the engine to catch the used oil,
then remove the oil filler cap, oil drain plug and washer.
2. Allow the used oil to drain completely, then reinstall the oil drain
plug and a new washer, and tighten the oil drain plug securely.
3. With the engine in a level position, fill with the recommended oil
(see page 8) to the upper limit.
Engine oil capacity: 1.1 L (1.0 lmp qt)
Running the engine with a low oil level can cause engine
damage. This type of damage is not covered under the
Warranty.
The Oil Alert system (applicable types) will automatically stop
the engine before the oil level falls below the safe limit.
However, to avoid the inconvenience of an unexpected
shutdown, fill to the upper limit, and check the oil level
regularly.
4. Install the oil filler cap and tighten securely.
OIL FILLER CAP
UPPER LIMIT
WASHER
OIL DRAIN PLUG
Wash your hands with soap and water after handling used oil.
Please dispose of used motor oil in a manner that is compatible
with the environment. We suggest you take it in a sealed
container to your local service station for reclamation. Do not
throw it in the trash, pour it on the ground, or pour it down a
drain.
REDUCTION CASE OIL (applicable types)

Recommended Oil

Use the same oil that is recommended for the engine (see page 8).
Oil Level Check
Check the reduction case oil level with the engine stopped and in a
level position.
1/2 Reduction Case With Centrifugal Clutch
1. Remove the oil filler cap/dipstick and wipe it clean.
2. Insert and remove the oil filler cap/dipstick without screwing it
into the filler hole. Check the oil level shown on the oil filler cap/
dipstick.
3. If the oil level is low, add the recommended oil to reach the
upper limit mark on the dipstick.
4. Screw in the oil filler cap/dipstick and tighten securely.
ENGLISH
OIL LEVEL
OIL FILLER CAP/DIPSTICK
UPPER LIMIT
9