Refueling; Engine Oil; Recommended Oil; Oil Level Check - Honda GXV160 Manuel De L'utilisateur

Masquer les pouces Voir aussi pour GXV160:
Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

REFUELING

Recommended Fuel
Unleaded gasoline
U.S.
Except U.S.
This engine is certified to operate on unleaded gasoline with a pump
octane rating of 86 or higher (a research octane rating of 91 or higher).
Refuel in a well ventilated area with the engine stopped. If the engine has
been running, allow it to cool first. Never refuel the engine inside a
building where gasoline fumes may reach flames or sparks.
You may use unleaded gasoline containing no more than 10% ethanol
(E10) or 5% methanol by volume. In addition, methanol must contain
cosolvents and corrosion inhibitors. Use of fuels with content of ethanol
or methanol greater than shown above may cause starting and/or
performance problems. It may also damage metal, rubber, and plastic
parts of the fuel system. Engine damage or performance problems that
result from using a fuel with percentages of ethanol or methanol greater
than shown above are not covered under the Warranty.
Gasoline is highly flammable and explosive.
You can be burned or seriously injured when handling fuel.
• Stop the engine and let it cool before handling fuel.
• Keep heat, sparks, and flame away.
• Handle fuel only outdoors.
• Keep away from your vehicle.
• Wipe up spills immediately.
Fuel can damage paint and some types of plastic. Be careful not to spill fuel
when filling your fuel tank. Damage caused by spilled fuel is not covered
under the Distributor's Limited Warranty.
Never use gasoline that is stale, contaminated, or mixed with oil. Avoid
getting dirt or water in the fuel tank.
1. With the engine stopped and on a level surface, remove the fuel filler
cap and check the fuel level. Refill the tank if the fuel level is low.
2. Add fuel to the bottom of the maximum fuel level limit of the fuel
tank. Do not overfill. Wipe up spilled fuel before starting the engine.
FUEL FILLER CAP
Refuel carefully to avoid spilling fuel. Do not fill the fuel tank completely.
It may be necessary to lower the fuel level depending on operating
conditions. After refueling, screw the fuel filler cap back on until it clicks.
Keep gasoline away from appliance pilot lights, barbecues, electric
appliances, power tools, etc.
Spilled fuel is not only a fire hazard, it causes environmental damage.
Wipe up spills immediately.
8
Pump octane rating 86 or higher
Research octane rating 91 or higher
Pump octane rating 86 or higher
MAXIMUM
FUEL LEVEL

ENGINE OIL

Oil is a major factor affecting performance and service life.
Use 4-stroke automotive detergent oil.

Recommended Oil

Use 4-stroke motor oil that meets
or exceeds the requirements for
API service classification SJ or
later (or equivalent). Always
check the API service label on the
oil container to be sure it
includes the letters SJ or later (or
equivalent).
SAE 10W-30 is recommended for
general use. Other viscosities shown in the chart may be used when the
average temperature in your area is within the indicated range.

Oil Level Check

Check the engine oil level with the engine stopped and in a level
position.
1. Remove the oil filler cap/dipstick and wipe it clean.
2. Insert the oil filler cap/dipstick into the oil filler neck as shown, but do
not screw it in, then remove it to check the oil level.
3. If the oil level is near or below the lower limit mark on the dipstick, fill
with the recommended oil to the upper limit mark. Do not overfill.
4. Screw in the filler cap/dipstick securely.
UPPER LIMIT
Running the engine with a low oil level can cause engine damage. Engine
FUEL FILLER
damage caused by running the engine with a low oil level is not covered
NECK
under the Distributor's Limited Warranty.
ENGLISH
AMBIENT TEMPERATURE
OIL FILLER CAP/DIPSTICK
LOWER LIMIT

Publicité

Table des Matières
loading

Table des Matières