Adjusting Armrests; Adjusting Leg Supports - Vermeiren INOVYS Mode D'emploi

Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

  • FRANÇAIS, page 25
GB
ADJUSTING THE ARMRESTS
2
1
ADJUSTING THE LEG SUPPORTS
A
B
5
4
3
A
A
C
HEIGHT ADJUSTING
Pull out the safety screw (1)
Pull the armrest into the required position (2)
Let go of the safety screw until it clicks into the
desired position (1)
Turn the safety screw securely for additional
tightening (3)
DEPTH ADJUSTING OF ARM CUSHION
Loosen the fixing screw beneath the arm cushion
(4)
Push the arm cushion into the desired position (5)
Then retighten the fixing screw (4)
WIDTH ADJUSTING OF THE ARMRESTS
Loosen the screws (A) of the armrest sockets
beneath the seat.
Pull the armrest socket into the desired position
(max. of 1.97 in outwards).
Tighten the screws (A) finger-tight again.
L
Pull out the armrest socket only to the extent
that both screws on one side still secure the
armrest socket.
The angle of inclination can be easily adjusted by
lifting the leg support with one hand. When letting go,
it will automatically lock in the desired angle (up to
113°). To lower the leg support, pull the handle (A) up
until the desired angle is reached.
L
To adjust the angle of the leg supports, only
touch them at the level of the footplates –
otherwise fingers may be squashed !
ADJUSTING CALF CUSHIONS
Adjusting the height:
Loosen the screw of the clip block (B), bring it to the
desired height and retighten the screw firmly.
Adjusting the depth:
Loosen the screw (C), bring the calf cushion on the
rail into the desired depth, and then tighten the screw
again firmly.
8
INOVYS
12/2008

Publicité

Table des Matières
loading

Table des Matières