Adjusting Head Rest - Vermeiren INOVYS Mode D'emploi

GB
L
Before using the leg supports, make sure that all screws and adjusting units have been
tightened properly.
Please keep in mind that the selection of adjusting functions and settings have an effect on the user.
Should you be uncertain whether the set functions and adjustments are suited for the user, please get
in touch with your specialist dealer.
ADJUSTING THE HEADREST
To support the head to the side, the headrest can be adapted to the head by slightly pressing the side
panels forwards. In this way, tipping of the head to the side can be avoided.
L
Make sure that all adjusting screws are properly tightened.
L
Make sure that the settings of the headrest correspond to the posture of the patient, and no
pressure or resistance is exercised.
L
Settings for the headrest must be done by authorized people only.
A B
ADJUSTING THE HEIGHT/DEPTH
Loosen the levers (1) and put the headrest into the position
2
desired. Levers (1) must then be retightened properly.
ROTATION OF THE CUSHION FRAME
1 The cushion frame can be turned up to 360° to adjust to a
3
slanted head position. Loosen the lever screws (2) and turn
the cushion frame into the position desired. The lever must
1
then be retightened properly.
ADAPTING THE SIDE OF THE CUSHION FRAME
1
The cushion frame can be pushed sideways. Loosen the
screw (3) and push the cushion frame into the position
desired. The screw must then be retightened properly.
ADJUSTING THE WIDTH
Loosen the screw (A for right / B for left) and the leg
support socket can be moved further out by about
2.36 in. After selecting the desired position, secure the
screw (A and/or B) again firmly.
L
Pull out the leg support socket only to the
extent that both screws on one side still
secure the leg support socket.
10
INOVYS
12/2008