Adjusting The Armrests - Vermeiren Normandie 2F Mode D'emploi

Entrapment zones are indicated in the figure above with .
Inclination of the comfort chair:
1. Engage the brakes (only for Normandie 2F + wheels).
2. The inclination of the comfort chair can be adjusted with the adjusting levers on
the side next to the seat tubing at the height of the armrest socket. (When inclining
the comfort chair see that there is enough space between the comfort chair and
the wall: 380 mm).
2.4

Adjusting the armrests

The armrests can be adjusted in height and can be lowered to the height of the seat frame
for the sideways transfer of the patient.
Armrests adjusted in height:
L
Risk of injury - If the locking spring  is guided outside the
WARNING:
armrest socket , the armrest is not locked. Use these position only for the
sideways transfer of the patient.
Lightly pull up the grey lever, the
pneumatic spring is released and the
backrest can be moved into the desired
position. If you let the lever go again, the
pneumatic spring is blocked and the
backrest stops at the desired position
(inclination: 10° - 45°).
Lightly pull up the black lever, the
pneumatic spring is released and the
legrest can be moved into the desired
position. If you let the lever go again, the
pneumatic spring is blocked and the
legrest stops at the desired position
(inclination: 0° - 82°).
Pull the lever of the armrests  upwards
(in the direction of the armpad).
The locking spring  will then be
released and the armrest can be moved
within the armrest socket  into the
desired position (Range 57 mm: 4
positions: steps 19 mm).
The 3 upper holes of the guide part 
shall not be used.
Page 9
Normandie 2F
2017-03