Autoclave Sterilisation Of The Front Terminal Of The Polisher; Scheduled Maintenance - Mectron easyjet pro Notice D'utilisation Et D'entretien

06.3 Autoclave sterilisation of the front terminal of the polisher

1 Disconnect the front terminal of the polisher from the body of the Easyjet pro (Fig.3 - Ref.C).
2 Free the channel from any residues of powder using the cleaning needle included in the supply (Fig.2
- Ref.C) carrying out the movements indicated (Fig.5). Blow compressed air into the central hole of
the terminal from both sides with the syringe.
�
WARNING: Use only the cleaning needle supplied with the apparatus to clean the channel
of the nozzle (Fig.2 - Ref.C).
�
WARNING: If the water is too hard, this may cause the spray of water to be too weak. To
3
eliminate thus problem, dipping the front terminal of the polisher in a 2 % solution ot hydrochloric acid
for a few minutes is recommended.
�
WARNING: Rinse the terminal thoroughly in distilled water to eliminate all the residues of the
hydrochloric acid solution. Dry it by blowing compressed air into the central hole of the terminal from
both sides with the syringe.
4 Disinfect the terminal using a mild disinfectant solution with a neutral pH. Dry it by blowing
compressed air into the central hole of the terminal from both sides with the syringe.
5 Insert the cleaning needle into the channel in the front terminal and seal both items inside a
disposable bag.
6 Sterilise the bag containing the front terminal of the polisher and the cleaning needle.
�
WARNING: Blow compressed air into the front terminal with the syringe before using it again, to
make sure that no residual mixture is left inside it.
1 If the air passage in the front terminal gets clogged, it is sufficient to switch on the device for a few
seconds and to use the needles included in the supply (Fig. 5) to free the channel from any resides of
powder.
2 If the front terminal gets clogged due to the excessively hard water, it is recommended to dip it in a
2 % solution of hydrochloric acid for a few minutes.
3 Whenever the front terminal is removed, it is necessary to blow compressed air with the syringe, both
into the cavity of the handpiece connector and into the rear central hole of the front terminal, so as to
avoid the accumulation of residues of powder.
4 To avoid clogging, it is advisable to empty the powder container of the Easyjet pro at least once a day.
easyjet pro - manual of use and maintenance

07.0 Scheduled maintenance

Fig. 5
EN
31