Installation; General - Hatco GR3SDH-27 Manuel D'installation Et D'utilisation

English

General

Glo-Ray Heated Glass merchandisers are shipped with most
®
components pre-assembled. Care should be taken when
unpacking shipping carton to avoid damage to the unit and
components enclosed.
WARNING
ELECTRIC SHOCK HAzARD: Unit is not weatherproof.
Locate unit indoors where ambient air temperature is a
minimum of 70°F (21°C).
FIRE HAzARD: Install unit with a minimum of 3" (76 mm) of
space from rear of unit to a back wall. If safe distances are
not maintained, discoloration or combustion could occur.
CAUTION
Locate unit at proper counter height in an area that is
convenient for use. Location should be level to prevent
unit or its contents from falling accidentally and strong
enough to support the weight of the unit and contents.
NOTICE
Do not lay unit on front or back side. Damage to unit could
occur.
NOTE: Due to the size and weight of Heated Glass
Merchandisers, installation of a unit will require two or
more people.
1. Remove the unit from the carton.
NOTE: To prevent delay in obtaining warranty coverage, complete
online warranty registration. See the ImPORTaNT
OWNER INFORmaTION section for details.
2. Remove tape and protective packaging from all surfaces of
the unit.
3. If installing 2-1/2" (64 mm) or 4" (102 mm) legs, follow the
procedure below. If installing a countertop mounted unit,
continue to the next step.
a. Remove all channel dividers and product divider rods.
NOTE: The side glass panels are shipped loose. Make sure
they are not installed before tipping unit.
b. Carefully lay unit on its side and remove the four rubber
shipping feet, if installed.
c. Screw the 2-1/2" (64 mm) or 4" (102 mm) legs into the
same holes where the four rubber shipping feet were
removed.
d. Remove the two venting panels on both sides of the unit
by removing the four screws.
e. Return unit to the upright position.
2-1/2" (64 mm) Leg
Installing the Legs
Form No. GR3SDm-0915
4. Place the unit in the desired location.
5. If installing a countertop mounted unit, apply National
6. Slide each glass side panel into the top channel, then lower
7. Install the product divider rods into the channel dividers, if
8. Install any accessories that came with the unit. Refer to the
9. Plug the unit into a properly grounded electrical receptacle
Vented
Side Panel
(remove)
Screw
9
• Locate the unit in an area where the ambient air
temperature is constant and a minimum of 70° F
(21° C). avoid areas that may be subject to active air
movements or currents (i.e., near exhaust fans/hoods
and air conditioning ducts).
• make sure the unit is at the proper counter height in an
area convenient for use.
• make sure the countertop is level and strong enough to
support the weight of the unit and food product.
• make sure the feet on the bottom of the unit are
positioned securely on the countertop.
Sanitation Foundation-approved (NSF) silicone around the
perimeter of the unit.
the panel into the bottom channel.
Glass Side Panel angled slightly.
Installing the Glass Side Panels
desired. The rods can be adjusted easily to separate
holding areas as needed.
OPTIONS aND aCCESSORIES section for details.
of the correct voltage, size, and plug configuration. See the
SPECIFICaTIONS section for details.

INSTALLATION