Hatco GR3SDH-27 Manuel D'installation Et D'utilisation page 15

English
12" (305 mm) Top Shelf Sign Holder
a 12" (305 mm) top shelf sign holder (sign not included) is
available for the top shelf only. The top shelf sign holder is
available as an accessory and adds 14-1/4" (362 mm) to the
height of the unit.
Use the following procedure to install the top shelf sign holder.
WARNING
ELECTRIC SHOCK HAzARD:
• Turn power switch OFF, unplug power cord, and allow
unit to cool before performing any maintenance or
cleaning.
• This unit must be serviced by qualified personnel only.
Service by unqualified personnel may lead to shock or
burn.
1. Turn off and unplug the unit. allow the unit to cool
completely.
2. Remove the channel divider rods and channel divider on
the control side of the unit.
3. Remove the channel divider brackets on the control side by
removing the nuts attaching them to the unit.
GR3SDS Model Shown
Sign Holder
Form No. GR3SDm-0915
(rear)
12" (305 mm) Top Shelf Sign Holder Installation
OPTIONS AND ACCESSORIES
4. align the holes on the sign holder brackets with the holes
previously used to secure the channel divider brackets.
NOTE: Make sure the sign holder is facing away from the control
side of the unit when installing the sign holder.
5. Secure the sign holder to the unit.
a. Place the channel divider bracket studs through the sign
holder bracket holes.
b. Tighten the nuts under the top of the unit.
6. Place the channel divider between the two channel divider
brackets.
15
Channel
Divider
Channel
Divider
Bracket
Sign Holder
Bracket
Nut