Original Accessories/Auxiliary Equipment; Safety Guidelines For Battery Chargers; Before Use; Charging The Battery Pack (See Fig. A) - Parkside PSBSA 20-LI B2 Traduction Des Instructions D'origine

■ Always start drilling at a low speed and with
the drill bit in contact with the workpiece. At
higher speeds, the drill bit can bend slightly if
allowed to turn freely without being in contact
with the workpiece and this can lead to injuries.
■ Do not exert excessive pressure and only
along the length of the drill bit (no lateral
pressure). Drill bits can bend and break, which
can lead to a loss of control and injuries.
Original accessories/auxiliary
equipment
■ Use only the accessories and additional
equipment which are specified in the operat-
ing instructions and are compatible with the
appliance.
WARNING!
■ Do not use any accessories which are not
recommended by PARKSIDE. This can lead to
an electric shock and fire.
Safety guidelines for battery
chargers
This appliance may be used
■
by children aged 8 years and
above and by persons with lim-
ited physical, sensory or mental
capabilities or lack of experi-
ence and knowledge, provided
that they are under supervision
or have been told how to use
the appliance safely and are
aware of the potential risks. Do
not allow children to use the ap-
pliance as a toy. Cleaning and
user maintenance tasks may not
be carried out by children unless
they are supervised.
│ GB │ IE
■ 20
To avoid potential risks, dam-
■
aged mains cables should be re-
placed by the manufacturer, their
customer service department or
a similarly qualified person.
The charger is suitable for indoor use
only.
WARNING!
■ To avoid potential risks, damaged mains ca-
bles should be replaced by the manufacturer,
their customer service department or
a similarly qualified person.
ATTENTION!
♦ This charger can only charge the following bat-
teries: PAP 20 A1 / PAP 20 A2 / PAP 20 A3.
♦ A current list of battery compatibility can be
found at www.lidl.de/Akku.

Before use

Charging the battery pack (see fig. A)
CAUTION!
► Always unplug the appliance before you
remove the battery pack from or connect the
battery pack to the charger.
♦ Connect the battery pack
battery charger
♦ Insert the power plug into the socket. The control
LED lights up red.
♦ The green LED indicates that the charging
process is complete and the battery pack
ready.
CAUTION!
♦ If the red control LED
that the battery pack
cannot be charged.
♦ If the red and green control LEDs
flash, this means that the battery pack
broken.
to the high-speed
(see fig. A).
flashes, this means
has overheated and
both
PSBSA 20-Li B2
is
is