Original Accessories / Tools; Charging The Battery Pack; Insertion / Removal Of A Battery Pack Into The Appliance; Checking Battery Status - Parkside PABS 14.4 A1 Instructions D'utilisation Et Consignes De Sécurité

General safety advice for electrical power tools / Start-up
prepared for high reaction torques as they may
cause kickback. The inserted tool will jam if it is
overloaded or if it becomes stuck in the work-
piece.
When working on the device as well
as transporting or storing it, put the
rotary direction switch in the middle
position (lock). Therefore preventing the
power tool from starting unintentionally.
DANGER! Check that you will not hit
electric, gas or water lines whilst using
the power tool. Check, if need be with a
service line detector, before you start to cut or
bore into a surface.

Original accessories / tools

Use only the accessories and attachments
detailed in the operating instructions,
or those which are compatible with
the device.
Start-up

Charging the battery pack

CAUTION! Always ensure the plug is removed
from the mains socket before inserting a battery pack
into, or removing one from, the charging station.
N ever charge the battery pack if the ambient
temperature is less than 10 °C or greater than
40 °C.
1. Insert the battery pack
(see Fig. C).
11
2. Insert the mains plug into the mains socket. The
status LED will light up red.
12
3. The green charging status LED
charging process has been completed and the
battery pack is ready for use.
4
4. Slide the battery pack
N ever charge the battery pack for a second time
immediately after a fast charging process has
been completed. This can give rise to the battery
30 GB
in the quick charger
4
indicates the
13
into the unit.
4
pack becoming overcharged and to a reduced
service life of the battery and charging station.
S witch the charger off for at least 15 minutes
between two successive charging procedures.
Remove the power plug from the wall socket.
Insertion / removal of a battery
pack into the appliance
Inserting the rechargeable battery pack:
Move the rotary direction switch
middle position (lock). Push the rechargeable
battery pack into the handle until it engages.
4
Removing the rechargeable battery pack:
P ress the release button
rechargeable battery pack

Checking battery status

Press the battery LED
condition (also see main image). The battery
display LED will indicate the status or the
6
remaining charge as follows:
GREEN / RED / ORANGE = maximum charge /
capacity
RED / ORANGE = medium charge / capacity
RED = weak charge – recharge battery

Changing tools

Your cordless drill has a fully automatic spindle
lock .
When the motor stops the power train will lock so
that you can open the drill chuck
After you have inserted the required bit and fixed it
in place by turning the chuck
ately continue working. The spindle lock releases
itself automatically when the motor is started (by
operation of the ON / OFF switch
into the
2
and remove the
5
to check the battery
7
by turning it.
9
, you can immedi-
).
3