Original accessories / auxiliary
equipment
■
Only use the accessories and additional
equipment which are specified in the
operating instructions and are compatible
with the appliance.
Operation
Additional handle
NOTE
►
For safety reasons, you should only use this
appliance with the additional handle
attached.
►
The appliance is fitted with an LED
This lights up red as soon as the appliance is
connected to the power supply.
This indicates that the appliance is connected
to the power and that it will turn on immedi-
ately if the ON/OFF switch is pressed
♦
The position of the additional handle
adjusted. Turn the wing screw
and swivel the additional handle
desired position.
♦
Then tighten the wing screw
Depth stop
♦
Open the wing screw
♦
Insert the depth stop
handle
.
♦
Ensure that the toothing on the depth stop
facing downwards.
♦
Pull the depth stop
distance between the tip of the drill and the tip
of the depth stop to correspond with the
required drilling depth.
♦
Retighten the wing screw
│ GB │ IE
■
16
.
.
can be
anti-clockwise
into the
again.
.
into the additional
out far enough for the
afterwards.
Fitting/removing a tool
WARNING!
►
Switch the appliance off and remove the
power plug before starting any work on the
appliance.
Fitting a tool:
♦
Before fitting a tool into the tool holder
grease it lightly.
♦
To insert, pull the locking collar
and insert the tool.
♦
Release the locking collar
tool holder
locked by pulling it. The system has radial play
because of the design.
Removing a tool:
♦
To remove the tool, pull the locking collar
backwards.
Quick-release chuck for round shaft
drill bits
WARNING!
►
Do not use the quick-release chuck
hammer drilling or chiselling!
♦
Set the function selector switch
symbol .
Inserting the quick-release chuck for round
is
shaft drill bits:
♦
To insert the quick-release chuck
fig. A) pull the locking collar
Insert the quick-release chuck
♦
Release the locking collar
tool holder
locked by pulling it.
Removing the quick-release chuck for round
shaft drill bits:
♦
To remove the quick-release chuck
locking collar
quick-release chuck
backwards
. This locks the
. Check that the tool is properly
to the drill
(see also
backwards.
.
. This locks the
. Check that the tool is properly
backwards and remove the
.
PBH 1050 B2
,
for
, pull the