Cleaning And Care - SOLIS 5511 Mode D'emploi

SOLIS Premium Kettle E_2015 16.06.16 11:05 Seite 65
▲

CLEANING AND CARE

1. Before cleaning, pull the plug and let the electric kettle cool down completely.
2. Never submerge the jug or the appliance base in water or any other liquids and
do not spray water or any other liquids onto the appliance parts. Risk of electric
shock!
3. Clean the outside of the jug, the lid on both the inside and the outside and the
appliance base with a just slightly wet cloth and dry the inside of the jug. Do not
use any aggressive cleaning agents or solvents and no scratching materials to clean
the appliance, this might damage the surfaces.
Tip: Light limestone deposits can be often removed by simply wiping the inside
of the jug.
■
R E M O V I N G A N D C L E A N I N G T H E L I M E S T O N E F I LT E R
• The limestone filter, which is positioned
directly behind the spout in the jug, has
to be removed and cleaned regularly.
• Always wait for the appliance to cool
down completely and check if the
power plug is pulled.
• Pull the filter up and out of the guide
rail.
• Clean the limestone filter under run-
ning, warm water with a towel or a soft
washing-up brush to free the filter from
limestone deposits.
• Place the filter back in the guide rail
and push it all the way down so that it
firmly locks into place.
Caution: If the filter is not pushed down all the way, the lid of the jug can not
be fully closed.
Note:
• The limestone filter is a consumable item and might be worn out after prolonged
use. You can get a replacement from good specialist stores or from Solis of
Switzerland Ltd, Telephone: 0848 804 884, Telefax: 0848 804 890, email:
info@solis-onlineshop.ch, www.solis-onlineshop.ch (shipping only within Switzer-
land).
65