Table des Matières
Publicité
Les langues disponibles
Les langues disponibles
C LEAN IN G A N D C A R E
▲
▲
Before cleaning, pull the plug and let the electric kettle cool down completely.
●
▲
Never submerge the kettle or the appliance base resp. the power cord and the
●
▲
power plug in water or any other liquids and do not spray water or any other
liquids onto the appliance parts. Risk of electric shock! Put neither the unit`s base
nor the kettle into a dishwasher.
Clean the outside of the kettle, the lid on both the inside and the outside and the
●
▲
appliance base with a just slightly moist cloth and dry the inside of the kettle. Do
GB
not use any aggressive cleaning agents or solvents and no scratching materials
to clean the appliance, this might damage the surfaces.
Tip: Light limestone deposits can be often removed by simply wiping the inside
of the kettle.
RE MOVI NG A ND CLE AN IN G THE LIM ES TONE FILTE R
▲ ■
The limestone filter, which is positioned
●
▲
directly behind the spout in the kettle,
has to be removed and cleaned regu-
larly.
Always wait for the appliance to cool
●
▲
down completely and check if the
power plug is pulled.
To take out the filter press down the
●
▲
filter nose at the upper rim of the kettle
above the spout.
To clean the filter of lime residue, scrub
●
▲
the filter under running, warm water
with a cloth or a soft dish scrubber.
Afterwards put the limestone filter back into the interior of the kettle. The bot-
●
▲
tom of the filter fits exactly into the bottom rail below the spout and the top of
the filter should snap in below the rim of the kettle.
Note: The limestone filter is a consumable item and might be worn out after
●
▲
prolonged use. You can get a replacement from good specialist stores or from
Solis. You can find the contact addresses at the end of the manual.
80
80
D ESCALI NG THE KETTLE
▲ ■
After prolonged use or through hard water, lime deposits can form in the kettle
●
▲
and reduce operating performance and impair the water taste.
Solis recommends to decalcify the kettle regularly (depending on the hardness of
●
▲
the water but at least once a month) using a mixture of a suitable lime dissolver
and water. Follow the instruction manual of the lime dissolver. The lime dissolver
or the lime dissolver solution (lime dissolver mixed with water) must not be boiled
under any circumstances.
The maximum amount of lime dissolver solution must not exceed 1,7 litres.
●
▲
Make sure to put the water kettle on a impervious resp. safe surface.
●
▲
After the lime dissolution process slowly pour the descaling solution out through
●
▲
the spout to descale that area as well. Remove possibly remaining limestone
deposits on the spout or limestone filter with a towel soaked in the descaling
solution.
After emptying out the descaling solution, you have to fill the kettle with fresh,
●
▲
cold tap water to the MAX marking, bring it to the boil (100 °C) and pour the
water out again each time to remove all remains of the descaling solution. Do
this three times and under all circumstances.
ST ORA GE
▲
▲
When not needed, the water kettle should be disconnected from the power, be
●
▲
allowed to cool down completely and then dried.
Store the cool, clean and dry appliance in an upright position, best in the original
●
▲
packaging. Do not place any objects on the appliance.
GB
81
81
Publicité
Table des Matières
