SOLIS 5511 Mode D'emploi page 66

SOLIS Premium Kettle E_2015 16.06.16 11:05 Seite 66
■
D E S C A L I N G T H E J U G
• After prolonged use or through hard water, lime deposits can form in the kettle
and reduce operating performance and impair the water taste.
• Solis recommends regularly (depending on water hardness, however at least once
a month) descaling your kettle with a mixture of SOLIPOL
use only SOLIPOL
caused by the use of unsuitable descaling agent are not covered by warranty.
• Pour 500 ml of cold water into the water jug and switch the appliance on. Bring
the water to the boil.
Take the water jug off the base, carefully open the lid (Caution, hot steam!) and
pour 1'000 ml SOLIPOL
reaches the MAX marking. Please ensure that the water jug is placed on a non-
sensitive resp. shielded worktop.
• Let the descaling solution sit for approx. 30 minutes. Do not boil!
• Slowly pour the descaling solution out through the spout to descale that area as
well. Remove possibly remaining limestone deposits on the spout or limestone
filter with a towel soaked in a solution of SOLIPOL
• After emptying out the descaling solution, you have to fill the kettle with fresh,
cold tap water to the MAX marking, bring it to the boil and pour the water out
again each time to remove all remains of the descaling solution. Do this three
times and under all circumstances.
▲
STORAGE
• When not needed, the water kettle should be disconnected from the power, be
allowed to cool down completely and then dried.
• Store the cool, clean and dry appliance in an upright position, best in the origi-
nal packaging. Do not place any objects on the appliance.
66
forte (art.-no. 703.01) for descaling the appliance. Damages
®
® forte into the water jug so that the descaling solution
® forte and water. Please
® forte and water.