Replacing Battery - Num'axes CANICALM First Guide D'utilisation

To increase the battery life, we recommend you to deactivate the collar if you are not using it for
a long period.
Operation

After setting up the battery, the collar remains on standby for 2 minutes to allow you time to fix the
collar on your dog.
bark, a beep sound is emitted.
At the 1
st
If a 2 bark is detected within 30 seconds, a beep sound and a low stimulation of short duration
nd
are emitted.
bark is detected within 30 seconds, a beep sound and a low stimulation of long duration are
If a 3
rd
emitted.
If a 4 bark is detected within 30 seconds, a beep sound and a strong stimulation of short duration
th
are emitted.
bark is detected within 30 seconds, a beep sound and a strong stimulation of long duration
If a 5
th
are emitted.
If your dog stops barking during 30 seconds, at the next bark, the collar will start its operating cycle
from the beginning (beep sound only).
After being activated 5 times in quick succession, the collar will automatically go into safety mode
for 2 minutes before restarting itself normally.

Replacing battery


NUM'AXES advises to use the same type and same brand of batteries as those supplied in your
new purchased product. Other brands of batteries may not operate, or may not be completely
compatible with your product.
You can purchase the suitable batteries from NUM'AXES or from you distributor.
Replace the battery as follows:
- Unscrew the battery cover using a coin.
- Remove the old battery.
Insert the new battery (Lithium 3-V CR2) paying attention to follow polarity indicated on the
-
collar (ref. Diagram 1).
Gb - 13