Settings; Maintenance - Melitta M600 Mode D'emploi

- Current time „Hour"
- Current time „Minute"
- Current day of the week
If you should want to return to a previous point (backwards),
hold button (5) depressed
(2)
Values and dates are always entered using buttons
(2) and (4)
Should you wish to leave the timer mode without change,
the machine must be switched off (button 1).
You can store the new values at any time and leave the
timer mode by holding button (5) „Clock" depressed for
about 3 seconds. A signal tone will sound.
The „ON" timer setting indicates the time when the water
boiler and heated storage urn are switched on. Should you
wish to have a specified quantity of prepared coffee at a
specified time, then the heating period (approx. 6 minutes),
brewing period (depending on quantity) and filter draining
period are to be taken into consideration.

Settings

• Switch machine on with button (1)
• Hold button (5)
A signal tone sounds. The display (3) shows the selec-
ted switching on time, e.g.
• The hour setting can now be adjusted to the desired
switching on time by using buttons (2)
(4) .
GB
• Press button (5)
the minutes setting, which can also be adjusted.
• Press button (5)
the days of the week on which the timer should be
active or passive.
• Using buttons (2)
choose between 0 = passive and 1 = active.
• Pressing button (5) briefly again allows you to set the
following days of the week.
10
Operating instructions - pages 7 - 12
and press button
.
ON
.
OFF
depressed for about 3 seconds.
ON AT
07:30
briefly. The display now shows
briefly. The display now shows
MONDAY
0
and (4) you can
• Press button (5)
current time of day
• The hour setting flashes and can be adjusted as requi
red using buttons (2)
• Press button (5)
minutes setting, which can also be adjusted.
• Press button (5)
shows
The day can now also be adjusted.
• Hold button (5)
3 seconds.
All new settings are now stored. A signal tone sounds.
The machine changes back to stand-by mode.

9. Maintenance

A water filter should be installed in the water supply pipe.
This filter system reduces greatly the amount of scaling in
the machine and has a decisive effect on the quality of the
water. It is therefore of immense importance for the quality
of the coffee and the safe operation of the machine.
and After approx. 5,000 litres, the cartridge should be changed
according to the instructions supplied with the spare car-
tridge. The new cartridge must be activated before use by
allowing at least 10 litres of water to flow through the fully
opened tap.
The cartridge must be changed at least 1 x per year.
• If the replacement time has arrived, the cartridge
should be replaced as soon as possible. To ensure
speedy replacement, MELITTA Technical Service
should be contacted. The replacement date must be
entered in the maintenance card.
Please call our Technical Service.
• Depending on the degree of hardness of the water and
the frequency of use, the machine requires regular de-
scaling. (Hard water and frequent use = more frequent
descaling).
For reasons of safety, this should only be carried out
by MELITTA Technical Service staff.
• To carry out regular maintenance and thereby secure
constant operation of your machine, we recommend
taking out a service contract with our Technical Service
staff. Please request information as to our service
agreements.
briefly. The display shows the
TIME
10:15
and (4) .
briefly. The display shows the
briefly again. The display
DAY
MONDAY
depressed for about