Display Messages, Tips To Rectify Possible Malfunctions - Melitta M600 Mode D'emploi

and handling. Any components replaced become our pro-
perty. They must be placed at our disposal.
Any damage to the appliances arising as a consequence of
inadequate maintenance and care will not be covered by
us, even during the warranty period. We do not offer any
warranty for defects and faults in our appliances originating
from inexpert repair work or the installation of spare parts

13.Display messages, Tips to rectify possible malfunctions

VERSION
V2.05
Malfunction / Display
Coffee does not taste good
Coffee too cold
Coffee too weak
Coffee too hot
Selected beverage quantity
is not correct
Filtering process takes longer
WATER
GB
LACKING
Temp.
20 Ltr.
CHECK
POSITION
SENSOR
ERROR
Break
20 Ltr.
M620
10:15
In the case of all other malfunctions, please contact the Customer Service of MELITTA SystemService.
12
Operating instructions - pages 7 - 12
On switching on the machine, the currently installed software version is displayed for
approx. 1 second. If required, give this number to Technical Customer Service staff.
Cause
• Coffee stored over 1 hour
• Poor quality ground coffee
• Residual descaling or washing
agent in machine
• Storage urn open
• Storage urn heater /
temperature control defective
• Defective plug socket (21) fuse
• Insufficient coffee dosage
• Small amount of coffee stored
too long
• The actual amount can vary by
approx. +/- 5%
• Excessive scaling in hot water unit
• Very fine ground coffee, very soft-
water = pores of filter paper clogged
• Incorrect water pressure
• Water hose to hot water unit clogged
• Incorrect water pressure
• Water hose to hot water unit clogged
• Water temperature not reached
• Incorrect position of swivel arm,
hot water unit or serving trolley
• Sensor in hot water unit defective
• „START - STOP" button (6) pressed
• Machine disconnected from mains
flashes for over 48 hours
not conforming with the original construction. Excluded from
the warranty are all porcelain and glass components as well
as all components subject to normal wear and tear. These
include, amongst others, seals, valves, taps, heat resistors,
varnishes, switches and thermostats. Acknowledgement of
warranty damage only after written report of the Customer
Service Department and inspection at the factory.
Solution
Use freshly filtered coffee
as quickly as possible.
Contact coffee supplier.
Rinse machine with water.
Replace lid / condensate lid.
Contact Customer Service.
Contact Customer Service.
Increase coffee dosage.
Use freshly filtered coffee as
quickly as possible.
Take into consideration next
time by using +/- buttons.
Descale machine after filter
program has ended.
Choose coarser coffee grind.
Check water pressure and
adapt as required.
Check hose connection / water filter.
Open tap, check water pressure.
Check hose connection / water filter.
Wait for heating up process to end.
Correct position.
Contact Customer Service.
Press „START - STOP" button (6).
Set clock.