Em Model; Adjusting The Mowing Height; Switch On - Grin EM37 Manuel D'utilisation


Disconnecting the battery
Switch the lawn mower off, release the engine brake lever on
the handlebar (Fig.1_G) and wait for the blade to come to a
complete standstill. Then remove the battery.
1. Press the On/Off switch on the battery to stop the power
supply.
2. The LCD display turns off indicating that the system is no
longer powered.
3. Lift the battery until it is completely detached (Fig.4).
Note:
For all battery safety, operating, recharging and
disposal information, see the manual attached to the
battery ("GL3609" User manual).
4.1.3 BM...-82V models

Connecting the battery
1. Take the battery out of its packaging and press the red
button to switch it on to check its charging status. The blue
indicators prompt the battery's charging status. The battery
is not supplied fully charged.
2. Open the battery compartment on the back of the engine
(Fig.1_V) and insert the battery with the contacts facing
downwards (Fig.3).
3. Push the battery in the compartment until it locks. The
battery connects in only one way; if it does not connect
properly, do not force it, but check whether the battery has
been inserted in the right direction, as shown in the figure.
(Fig.3)

Disconnecting the battery
Switch the lawn mower off, release the engine brake lever on
the handlebar (Fig.1_G) and wait for the blade to come to a
complete standstill. Then remove the battery.
1. Open the battery compartment cover (Fig.1_V).
2. Press the battery release latch (Fig.4) at the upper side of
the compartment.
3. Take the battery out.
Note:
For all battery safety, operating, recharging and
disposal information, see the manual attached to the
battery ("82V Rechargeable Battery and Lithium Ion
Charger" User manual).

4.1.4 EM model

1. Connect the extension cord to the power plug next to the
starter button (Fig.1_X) and secure it to the handle bar with
the strain relief provision (Fig.1_Y).
2. Plug the extension cord into the mains.

4.2 Adjusting the mowing height

Set the mowing height with the adjustment lever.
Raise the height (Fig.5.1):
I. Pull the height adjustment lever (Fig.1_E) backwards
towards the handlebar.
II. Select the required height clicking the lever into place.
Lower the height (Fig.5.2):
I. Pull the handle upwards (Fig.1_F) and push the lever
forwards (Fig.1_E).
II. Select the required height clicking the lever into place.
Completely down, the lever is in the transport position.
(Fig.5.3_4).
7
Note:
Position 4 (lever completely down) is NOT to be
used for mowing, only for storing the machine as it allows
the handlebar to fold down completely.

4.3 Switch on

Caution!
ALWAYS and ONLY switch the lawn mower on when you
are behind the handlebar. The starter controls are easily
reached from this position. If the user stands next to the
lawn mower when it is switched on, there is a high risk of
injury to the feet given the proximity to the blade.

HM/PM/SPM models with starter cord:
1. Attach the starter cord (Fig.1_J) to the strain relief
provision on the handlebar (Fig.1_P).
2. Stand behind the lawn mower and with one hand pull
the engine brake lever towards you and hold (Fig.6.1
HM models; Fig.6.2 PM/SPM models); with the other
hand, pull the starter cord (Fig.1_J) with a quick and
powerful jerk. Hold the cord for a few seconds, even
after the engine has started.
3. When the engine is running, slowly release the starter
cord to rewind.
Note:
Too many start attempts can flood the engine.
Too much petrol is pumped into the engine and the spark
plug can no longer ignite. If, after several attempts, the
engine does not switch on, it is necessary to find the
cause, using the engine's user manual if need be .
If after numerous attempts the engine floods, follow these
operations:
I. Remove the spark plug cap.
II. Unscrew the spark plug.
III. Repeatedly pull the cord to dry the cylinder.
IV. Dry the spark plug and firmly screw it back in.
V. Put the spark plug cap back on.
VI. Start the engine.

HM/PM Instart models
Caution!
Improper use of the battery or charger can cause electric
shocks or fire:
-
Do not wet the battery charger.
- Do not expose the battery to wet or damp.
- Check whether the starter battery is charged by pressing
the button on the battery.
Note: See the engine's user manual before first start-up
or for more details on how to use and recharge it.
1. Slide the battery onto its mount on top of the engine, as
shown in the figure (Fig.6.3).
2. Stand behind the lawn mower and with one hand pull
the engine brake lever towards you and hold (Fig.6.3);
with the other hand press the starter button (Fig.1_U).
To extend the life of the starter, use short
starting cycles (5 seconds maximum). Wait for
a minute
procedure.
before repeating the starting
Translation