Installing The Smartphone Holder; Make The Model Ready To Start - Reely Nano Notice D'emploi

c) Installing the Smartphone holder
Install the Smartphone holder (1) on the transmitter by pushing the holder into the provided guide on the bottom of the
transmitter and securing it with a screw (2) against coming loose.
Insert your Smartphone into the holder as shown in figure 10. The holder is suitable for Smartphones with a width of
max. 90 mm. When installing your Smartphone, ensure that you neither damage the housing nor push/damage any
buttons. Observe a tight fit of the Smartphone during transport or operation of the transmitter. You can use the knurled
screw (3) to adjust or fasten the inclination of the holder and the knurled screw (4) to adjust and fasten the height of
the holder. The upper counter-bearing of the holder is also height-adjustable.
Figure 10
d) Make the model ready to start
Make your quadrocopter ready for operation by charging the flight battery in the quadrocopter and binding the quad-
rocopter with the activated transmitter.
57