Maintenance, Care And Repair; Regular Cleaning; Replacing The Rotors - Reely Nano Notice D'emploi

14. Maintenance, Care and Repair

a) Regular Cleaning
The quadrocopter "Nano" is a very simply built flight model. There are no mechanical parts that need to be lubricated
or require special maintenance. However, after each flight operation, you should clean the quadrocopter of possible
contamination (wool threads, hair, dust etc.).
Use a clean, soft and dry cloth for cleaning and avoid contact between water and the electronics, rechargeable battery
and motors.
Dust may be removed with a soft, clean brush or compressed air spray.
b) Replacing the Rotors
If a rotor is damaged in a crash or other action, replace it immediately. This also applies if there are any fine tears or
grazing in the rotor. Due to the high speed, material parts could come loose if the rotors are damaged and this could
lead to damage to or endangerment of the environment.
To replace a rotor, carefully lever the damaged rotor from the motor shaft with your fingertips and replace it with a new
one. Installation must be performed with the necessary caution and the corresponding care.
For orientation, put the quadrocopter onto your work surface so that the black rotors of the model point forward.
The rotating direction is marked on the rotors ("A" or "B"). The mark "A" or "B" points up.
The front rotors must have black rotors. Rotor A turns clockwise and is labelled "A", rotor B turns counter-clockwise
and is labelled "B".
The rear rotors must have white rotors. Rotor A turns clockwise (label "A"), rotor B turns counter clockwise (label "B").
The rotors marked "A" must be installed on the drive motors that turn rightwards (clockwise).
The rotors marked "B" must be installed on the drive motors that turn leftwards (counter clockwise).
Attention!
Please observe the rotating direction of the respective motor and the choice of the corresponding rotor
without fail. If these are incorrectly chosen, the model will not be able to fly and will act in an erratic way
when next started! Loss of guarantee/warranty!
Do not bend the drive shafts. Bent shafts (e.g. from crashes) influence the flight properties negatively due to the vibra-
tion that results and the irritation to the sensors.
62
Figure 17