Spinning Function - Reely Nano Notice D'emploi

When the model is already in "Low Batt" mode (all LEDs at the quadrocopter flash at the same time), the
flip function is deactivated for reasons of safety and therefore cannot be performed.
The model can perform a flip function only in one direction (only forward or backward; only to the left or
right) and therefore also requires the corresponding clear control commands from the transmitter (right
control lever forward or back; right control lever to the left or right). Therefore, avoid inadmissible control
commands when the flip function is activated, such as "right control lever pushed to the front/left". In such
cases, there may be uncontrolled flight conditions and crashes.
After a flip, the function is automatically deactivated again at the transmitter. If you want to perform another
flip, you need to activate the flip function at the transmitter first.
e) Spinning function
The model can perform "spinning" (quick 360° turns around its vertical axis) on the push of a button. The flight altitude
may be influenced during this by making the corresponding control movements on the left control stick (figure 3, item
4). For this, put the quadrocopter back in a stable hover flight at a minimum flight altitude of 1.5 metres (at sufficient
distance from the pilot and the obstacles, at least 2 metres).
Now push the "spinning button" (figure 3, item 10) briefly. The transmitter will emit a control sound to confirm that you
have chosen spinning mode. The quadrocopter will start to spin quickly around its vertical axis. End spinning mode by
pushing the button for spinning (figure 3, item 10) again or by moving the right control stick in any direction.
Attention!
The spinning function must only be performed if the model is flown in a large hall or outdoors in windstill
conditions, is in a stable flight condition (hovering) before the respective operating button is pushed at the
transmitter, the flight height is not below 1.5 metres and the quadrocopter is at least 2 metres away from
any obstacles and persons. If this is not observed, there is a danger of damage to the model or other
objects nearby and a danger of injury to persons/animals in the vicinity from contact or crash!
When the model is already in "Low Batt mode" (all LEDs at the quadrocopter flash at the same time), the
spinning function is deactivated for reasons of safety and therefore cannot be performed.
The model can only perform spinning in one direction (counter-clockwise).
53