General Machine Description; What Is Included; Operational Elements; Initial Operation And Transport - Migatronic GREEN POINTER PRO CUT Guide De L'utilisateur

IMPORTANT SAFETY INSTRUCTIONS
It is important to follow the safety rules
enclosed when installing and operating
the machine.
This instruction manual must be accessible
at all times to the person engaged in the
installation, operation and maintenance
of the machine.

1. General machine description

Green Pointer Pro Cut is a patented grinder and
cutting devise with diamond discs for wet grinding
and cutting of tungsten electrodes for TIG welding. It
is very easy and safe to use.
The diamond disc grinds the tungsten electrodes
correctly in the longitudinal direction of the electrode,
and the variable angle adjustment allows you, not
only to grind in the right angle, but also to grind the
tip flat, if needed.
Cutting function with the diamond-cutting disc, gives
an exact and sharp cut of the tungsten electrode in
the precise length, without any risk of damaging the
electrode.
The grinding liquid in the closed grinding and cutting
chambers ensures that no harmful dust particles
slips out into the surroundings. The cooling effect
of the grinding liquid also mean, that there are no
discoloration of the tungsten electrode due to heat.
The harmful grinding dust is collected automatically in
the special dust collector and hence can be disposed
correctly.
The included electrode holder and electrode clamps,
in combination with stick-out adjustment, reduces the
waste of electrodes, and ensures a uniform grinding
result at each grinding.
the Green Pointer Pro Cut can be used in a room with
an ambient temperature of 0°C to +40° and a relative
humidity of up to 50% at 40°C and 90% at 20°C.
The machine is tested acc. protection class IP21.

2. What is included

Upon reception und unpacking please, check that the
following items are included in the package:
• Green Pointer Pro Cut machine
• 2 dust collectors with liquid
• 2 x 250 ml bottles off grinding/cutting liquid
• Tungsten electrode holder
• Pickup
• Pickup release
• Electrode clamps for ø1.6 - ø2.4 and ø3.2 mm
• Clamps for cutting ø1.6 - ø2.4 and ø3.2 mm
• 2 x tip collector
• Worktable, incl. bolts and nuts for mounting

3. Operational elements

3
4
5
1. Power Switch
2. Degree scale
3. Electrode holder
4. Tightening screw to flatten the tip of the
electrode
5. Stick-out adjustment
6. Length adjustment for cutting
7. Pickup
8. Tip collectors
9. Pickup release
10. Reset button
11. LED
12. Handle for cutting

4. Initial operation and transport

Remove the protective foil on the enclosed worktable
and mount the worktable as shown in the drawing
in the back of this manual. Fasten the grinder on the
worktable and place it securely on a workbench or
table.
IMPORTANT: The Green Pointer Pro Cut cannot run
without grinding liquid!
The Green Pointer Pro Cut grinder does not contain
grinding liquid on delivery. Before starting the
machine the first time, mount the supplied dust
collectors and fill extra grinding liquid from the
bottle provided through the tube until the correct
liquid level has been reached (please see mark on the
inspection cover frame). (See drawing and photos in
the back of this manual).
Check that the switch is in the OFF position. ("O" on
the switch).
Connect the machine to the mains voltage specified
on the nameplate.
IMPORTANT: Only use single-phase power supply
outlet WITH an earth connection.
10
2
6
1
11
10
12
9
8
7