Menu Page Sound; Sound Settings; Menu Page Osd Setup; Basic Settings - Monacor TFT-1002LED Mode D'emploi

Table des Matières

Publicité

Les langues disponibles

Les langues disponibles

DNR (Digital Noise Reduction)
Select the level of noise reduction (Low, Medium,
High) or deactivate the noise reduction (Off) .
DLC (Dynamic Luminance Control)
Activate (On = picture reproduction with deeper
black) or deactivate (Off) the function .

6.11.2 Menu page Sound

Sound settings

Volume
Adjust the desired volume .
Mute
Activate (On = sound muted) or deactivate (Off)
the muting function . In contrast to an activa-
tion of this function via the button
ter 6 .6), Mute will not appear on the screen .
Sound Mode
Select one of the sound modes Live, Pop, Rock or
User . When the value of the parameter Bass or
Treble is changed, the monitor will automatically
go to the mode User . When the monitor is set to a
different sound mode or when it is disconnected
from the power supply, the modified values for
Bass and Treble will be reset to the User presets .
Bass, Treble
For tone control, adjust the desired values for the
low frequencies and high frequencies . When the
values are changed, the monitor will go to the
sound mode User (see above) .
Balance
Set the desired stereo balance (volume ratio of
left /right audio channel) .

6.11.3 Menu page OSD Setup

Basic settings

Language
Select the desired menu language (available
languages: English, French, German, Spanish,
Italian, Turkish, Polish, Czech, Japanese) .
Set ID
The ID number is required for the ID function
(
 chapter 6 .12): Set the desired ID number
for the monitor (0 ... 99) .
Gamma
For brightness correction of the grey values,
select the gamma value: 0, 1 or 2 .
Freeze
In the OSD menu, the freeze function is only
available for the source AV . Activate (On) or de-
activate (Off) the function . In contrast to an ac-
tivation of this function via the button "Freeze"
(
 chapter 6 .8), Freeze will not appear on the
screen .
Note: When the function has been activated (On) and
the monitor is switched to a different source or to
standby or when the monitor is reset to the factory
settings, the function will be deactivated . However, the
menu will still show On . To match the menu indication
and the setting, set the menu item to Off .
OSD Time
(
 chap-
Use this menu item to define the display time
of the OSD menu (in seconds) when the set-
tings have been made and no further button is
pressed . The time adjusted also applies to other
on-screen displays outside the menu, e . g . bar
graph for a parameter called up via the button
"Item" .
OSD Transparency
Use this menu item to adjust the transparency
of the OSD menu and of the on-screen displays:
The lower the value, the higher the transparency
of the background for the lettering . The setting
will not affect the OSD menu for USB connection
(
 chapter 6 .10) .
Recall
When the menu item has been activated with the
button "Source / ", the monitor will be reset to
the factory settings . This will take a few seconds .
You will exit the menu and the source AV will
be selected .
Screen Saver
To prevent shadow pictures (= persistence of
pre vious picture contents, may occur when still
pictures are shown for a longer time), an auto-
matic function will move the picture at regular
intervals . Activate (On) or deactivate (Off) the
function .
The last line on the menu page (information on
firmware version) is not adjustable .
21

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

18.4900

Table des Matières