Location And Installation; Unpacking - Kulzer cara Scan 4.0 Guide De Démarrage Rapide

6

Location and Installation

6.1

Unpacking

The cara Scan 4.0 is shipped inside a cardboard box.
1. Open the upper side of the cardboard box at the position where the clamps are
present.
2. Remove first the Accessory kit and afterwards the inner protective parts both on the
right as well as on the left side.
3. Remove the scanner.
4. Remove door protection.
5. Open the front door and check the position of the base plate. If the position is not
horizontal, gently move it by hand until it is roughly aligned with the inner cover.
The perfect base plate position will be achieved later on through the Reset Axis
procedure described in the "Operations" paragraph.
CAUTION
·
Do not perform this operation while the scanner is turned on!
W19641_REF_66069511_13_QSG_02GB_caraScan4.0_V02
© 2018 Kulzer GmbH
Location and Installation
7