Backlight - Steinberg Systems SBS-KW-1000B Mode D'emploi

The Auto-Off function maximizes the scale's battery life against people's care-
lessness not to power off the scale when it's not working. The Auto-Off starts to
countdown timer when there's no action or as soon as the load is stable. Any key
pressing or motion in load restarts the countdown timer.
Press or , and

Press or to exit without saving. Press

save.
Press or to enter the Brightness / Backlight setup.

3) IDLE TIME
The scale displays the idle time, e.g.
To maximize the battery life, the scale automatically enters the Idle Mode when
there's no action or the load is stable. In Idle Mode, the scale works in low-power
consumption status. Any key pressing or motion in load wakes up scale from Idle
Mode.
The idle time can be set to: 0 (never idle), 5sec, 15sec, 30sec, 60sec.
 Press or to exit without saving. Press
save.
 Press or to enter the Anti-Motion setup.
EN

4) BACKLIGHT

The scale displays LCD backlight status. Turning off the LCD backlight saves batte-
ry power. LCD display backlight turn on and off – 0 (backlight off), 1 (backlight on)
Press or , and

status.
Press or to exit without saving. Press

save.
Press or to enter Auto-Off again.

For the crane scale SBS-KW-1000/10B: the scale displays LED brightness
status, e.g. . Brightness can be set on 1 - the weakest brightness, 2 –
average brightness, 3 – the strongest brightness.
Press or to change the brightness level.
Press or , to exit without saving.
Press or , to exit and save.
Press or , to enter Anti-Motion setup.
to change the Auto-Off time.
or to exit and
, indicating 30sec.
or to exit and
to change the LCD backlight
or to exit and
33
5) ANTI-MOTION
The scale displays the Anti-Motion level to be set, e.g.
At the cost of measuring time, the Anti-Motion function intelligently settles the
determination of weight when the scale is in motion. The weaker Anti-Motion is,
the faster the scale displays the weight, but the longer it takes to be stable.
Anti-Motion can be set to: 0 (off), 1 (weakest), 2 (weak), 3 (normal), 4 (strong),
5 (strongest).
 Press
 Press
save.
 Press
III. SCALE CONFIGURATION
ATTENTION: The parameters in Scale Configuration are closely related
to the scale's metrology performance. It is NOT recommended to change
any parameters unless you absolutely need to. In case you´re not sure,
please contact the customer service to check if it is necessary to modify
these parameters.
1) DISPLAY
message
Rev. II.2017 Rev. II.2017
or , and to change the Anti-Motion level.
or to exit without saving. Press
or to enter Auto-Off again.
stands for note
Password password mode
SCALE scale configuration
Auto Zero range Auto-Zero range
Manual Zero range Manual-Zero range
Zero Track range Zero-Tracking range
Gravity gravity of acceleration
CaLiBRaTion calibration
LOAD0 load0 detection
LOAD1 load1 detection
LOAD2 load2 detection
LOAD3 load3 detection
User unit User Unit
Full Scale Max. Cap.
34
, indicating level 1.
or to exit and
EN