Receiving Measurements Automatically; Manual Measurement Display - Bresser 7007600000000 Mode D'emploi

3. Settings order: ON/OFF (Temperature alarm on/off) >
Temperature highest limit > Temperature lowest limit >
Exit
4. Press UP or DOWN button to change the value.
5. Press SET button to confirm and continue to the next
setting.
6. The temperature settings mode will be quit automatic-
ally after 30 seconds of inactivity. All settings done be-
fore will be saved.
7. When outdoor temperature reaches highest or lowest
limit, the temperature alarm symbol will flash and an
alarm will sound for approx. 3 seonds. This will be re-
peated with an interval of 1 minute until the temperat-
ure has fallen below the limit again.
NOTICE! NOTICE! Select temperature alarm OFF
from the temperature settings mode to disabled the
temperature alarm permanently.
15 Receiving measurements
automatically
Once batteries are installed, the base station will display the
measurement readings. Readings from the remote sensor
will be displayed within 3 minutes after powering it on.

16 Manual measurement display

1. Press UP button several times to display the saved val-
ues one after another.
2. Display order: Current values > MAX (highest values) >
MIN (lowest values)
33 / 76