Receiving Measurements Automatically; Display Brightness Regulation; Ec Declaration Of Conformity - Bresser Thermo Hydro Quadro NLX Mode D'emploi

11 Receiving measurements
automatically
Once the power supply is enabled, the base station will dis-
play the measurement readings for indoors. Readings from
the outdoor sensor will be displayed within 3 minutes after
powering it on.
If no signal is received, proceed as follows:
Press the CH button for about 3 seconds to initate reception
of measurements again.

12 Display brightness regulation

1. In normal display mode, press SNOOZE/LIGHT button,
to activate the full display brightness for 10 seconds.
2. In mains adapter operation (DC 5V) the backlight re-
mains always activated. The light sensor ensures that
the brightness is automatically reduced in a dark envir-
onment.
3. NOTICE! In battery mode the display brightness reg-
ulation is disabled.

13 EC Declaration of Conformity

Hereby, Bresser GmbH declares that the equipment type
with item number 7000023 : is in compliance with Directive:
2014/30/EU. The full text of the EU declaration of conform-
ity is available at the following internet address:
www.bresser.de/download/7000023/CE/7000023_CE.pdf
15 / 76