Snooze Function; Receiving Measurements Automatically - Bresser Thermo Hygro Quadro NLX Mode D'emploi

7. Finally press the SET button to save the settings and
exit the setting mode.
Enable/disable alarm
8. In normal display mode, press SET button to switch to
alarm time display (AL).
9. Press DOWN button to enable the alarm. The
will be displayed.
10. Press DOWN button again to disable the alarm. The
symbol will disappear from the display.

12 Snooze function

1. When the alarm sounds, press SNZ button to activate
the snooze function. The alarm will sound again in 5
minutes.
2. Press any other button when the alarm sounds to inter-
rupt the alarm until the alarm time will be reached
again.
13 Receiving measurements
automatically
Once the power supply is enabled, the base station will dis-
play the measurement readings for indoors. Readings from
the outdoor sensor will be displayed within 3 minutes after
powering it on.
If no signal is received, proceed as follows:
Press the CH button for about 3 seconds to initate reception
of measurements again.
symbol
15 / 84