Snooze Function; Receiving Measurements Automatically; Moon Phases - Bresser ClimaTemp FSX Mode D'emploi

12 Snooze function

1.
2.
3.
13 Receiving measurements
automatically
Once the power supply is enabled, the base station will dis-
play the measurement readings for indoors. Readings from
the outdoor sensor will be displayed within 3 minutes after
powering it on.
If no signal is received, proceed as follows:
Press 12/24 button for approx. 3 seconds to initate recep-
tion of measurements again.

14 Moon phases

This weather station is able to display the moon phases for
the northern hemisphere. Here the moon grows from the
right. This is because the sunlit side of the moon in the
northern hemisphere moves from right to left. The following
table shows the representations of the moon phases.
14 / 108
When the alarm sounds press the SNOOZE/LIGHT but-
ton to activate the snooze function. The alarm will
sound again in 5 minutes.
Press ALARM button when the alarm sounds to inter-
rupt the alarm until the alarm time will be reached
again.
The alarm will be turned off automatically if no button is
pressed within 2 minutes.