Setting Up Power Supply - Bresser 7007600000000 Mode D'emploi

supply must be disconnected for a short moment also for
this device when exchanging the batteries. If batteries are
exchanged in only one of the devices (i.e. the remote
sensor) the signal can't be received or can't be received
correctly.
Note, that the effective range is vastly affected by building
materials and position of the main and remote units. Due to
external influences (various RC devices and other sources
of interference), the maximum distance can be greatly re-
duced. In such cases we suggest to position the main unit
and the remote sensor at other places. Sometimes all it
takes is a relocation of one of these components of a few
inches!

9 Setting up power supply

Base station
1.
2.
3.
4.
Remote sensor
5.
6.
7.
8.
9.
30 / 76
Remove the battery compartment cover.
Insert the batteries into the battery compartment. En-
sure that the battery polarity (+/-) is correct.
Replace the battery compartment cover.
Wait until the indoor temperature is displayed on the
base station.
Remove the battery compartment cover.
Insert the batteries into the battery compartment. En-
sure that the battery polarity (+/-) is correct.
Push the CH button to set the desired transmission
channel (setting CH1, CH2 or CH3 on screen display).
Push the °C/°F button to set the desired temperature
format (setting °C or °F on screen display).
Replace the battery compartment cover.