11. Finally press the ALARM button to save the settings and exit the setting mode.
14 Snooze function
1. When the alarm sound starts, press the ALARM/SNOOZE button to activate the Snooze function.
The Alarm will sound again after 5 minutes.
2. When the alarm sound starts, press the ALARM button or press and hold the ALARM/SNOOZE
button for approx. 3 seconds, to stop the alarm.
3. The alarm will be turned off automatically if no button is pressed within 2 minutes.
15 Receiving measurements automatically
Once the power supply is enabled, the base station will display the measurement readings. Readings
from the remote sensor will be displayed within 3 minutes after powering it on.
Read the detailed manual for more information about readings (see download information on page 2).
16 Rainfall
The base station displays how many millimeters / inches of rainfall are accumulated over a time
period, based on the current rainfall rate.
Rainfall rate
Select display mode
Press the RAIN button several times until the desired time range is displayed:
RATE
DAILY
WEEKLY
MONTHLY
Select rainfall measurement unit (millimeter or inch)
1. Press and hold RAINFALL button for approx. 3 seconds to change to setting mode.
2. Press UP or DOWN button to change between mm (millimeter) and in (inch).
3. Finally press the RAINFALL button to save the settings and exit the setting mode.
17 HI/LO Alert
HI/LO alert are used to alert you of certain weather conditions. Once activated, an alarm sound is
triggered and the alert icon flashes as soon as a set value is reached. Supported areas and alarm
types:
Area
Indoor temperature
Indoor humidity
Outdoor temperature
Outdoor humidity
Rainfall (daily)
Wind speed
34 / 68
Daily rainfall
Current rainfall rate in past hour
Total rainfall rate within the current day, from midnight
Total rainfall rate for current week
Total rainfall rate for current month
Weekly rainfall
Type of alert available
HI AL / LO AL
HI AL / LO AL
HI AL / LO AL
HI AL / LO AL
HI AL*
HI AL
Monthly rainfall