Receiving Measurements Automatically; Temperature Alarm Setting; Precipitation - Bresser ClimaTemp XXL Mode D'emploi

Masquer les pouces Voir aussi pour ClimaTemp XXL:
Table des Matières

Publicité

Les langues disponibles
  • FR

Les langues disponibles

NOTICE! NOTICE! Select temperature alarm OFF from the temperature settings mode to dis-
abled the temperature alarm permanently.

19 Receiving measurements automatically

Once batteries are installed, the base station will display the measurement readings. Readings from
the remote sensor will be displayed within 3 minutes after powering it on.

20 Temperature alarm setting

1. In normal time display mode, press DOWN button for approx. 2 seconds to enter temperature
alarm time setting mode.
2. Digits to be set are flashing.
3. Settings order: ON/OFF (Temperature alarm on/off) > Temperature highest limit > Temperature
lowest limit > Exit
4. Press UP or DOWN button to change the value.
5. Press SET button to confirm and continue to the next setting.
6. The temperature settings mode will be quit automatically after 30 seconds of inactivity. All settings
done before will be saved.
7. When outdoor temperature reaches highest or lowest limit, the temperature alarm symbol will flash
and an alarm will sound for approx. 3 seonds. This will be repeated with an interval of 1 minute un-
til the temperature has fallen below the limit again.
NOTICE! NOTICE! Select temperature alarm OFF from the temperature settings mode to dis-
abled the temperature alarm permanently.

21 Precipitation

The precipitation which was collected over a certain period is displayed on the base station in milli-
meters or inches and is based on the current precipitation rate.
Select display mode
Press the RAIN button several times until the desired time range is displayed:
RATE
DAILY
WEEKLY
MONTHLY
Select measurement unit (millimeters or inch)
1. Press the RAIN button for approx. 3 seconds to change to measurement unit settings.
2. Press UP or DOWN button to change between mm (millimeters) and in (inch).
3. Finally press the RAIN button to save the settings and exit the setting mode.
NOTICE! Readings are updated automatically every 6 minutes.
28 / 80
Current precipitation rate in the past hour
Total precipitation rate of the current day, measured from midnight
Total precipitation rate of the current week
Total precipitation rate of the current month

Publicité

Table des Matières
loading

Ce manuel est également adapté pour:

7002420

Table des Matières