Activating Alarm Function; Wireless Sensor Signal Receiving; Temperature / Humidity Function; Comfort Indication - Bresser 7006300 Mode D'emploi

ACTIVATING ALARM FUNCTION

1 . In normal mode, press [ MODE / ALARM ] key to show the
alarm time for 5 seconds .
2 . When the alarm time displays, press [ MODE / ALARM ] key
again to activate the alarm function .
When clock reach the alarm time, alarm sound will start .
Where it can be stopped by following operation:
- Auto-stop after 2 minutes alarming if without any operation and the alarm will activate again in the next
day .
- By pressing [ALARM / SNOOZE] key to enter snooze that the alarm will sound again after 5 minutes .
- By pressing and hold [ALARM / SNOOZE] key for 2 seconds to stop the alarm and will activate again
in the next day
- By pressing [ MODE / ALARM ] key to stop the alarm and the alarm will activate again in the next
day .
NOTE:
- The snooze could be used continuously in 24 hours .
- During the snooze, the alarm icon "

WIRELESS SENSOR SIGNAL RECEIVING

1 . The console display signal strength for the wireless sensor(s), as per table below:
Signal strength of wireless
sensor channel
2 . If the signal has discontinued and does not recover within 15 minutes, the signal icon will
disappear . The temperature and humidity will display "Er" for the corresponding channel .
3 . If the signal does not recover within 48 hours, the "Er" display will become permanent . You
need to replace the batteries and then press [ SENSOR / WI-FI] key to pair up the sensor
again .
VIEW THE OTHER CHANNELS (OPTIONAL FEATURE WITH ADD ON EXTRA SENSORS)
This console is capable to pair with 7 wireless sensors . If you have 2 or more wireless sensors,
you can press [ CHANNEL ] key to switch between different wireless channels in normal mode,
or press and hold [ CHANNEL ] key for 2 seconds to toggle auto-cycle mode to display the
connected channels at 4 seconds interval .
During auto-cycle mode, the
console's display . Press [ CHANNEL ] key to stop auto cycle and display the current channel .

TEMPERATURE / HUMIDITY FUNCTION

- The temperature and humidity reading are display on the Channel and indoor section .
- Use the [ °C / °F ] key to select the temperature display unit .
- If temperature / humidity is below the measurement range, the reading will show "LO" . If temperature /
humidity is above the measurement range, the reading will show "HI" .

COMFORT INDICATION

The comfort indication is a pictorial indication
based on indoor air temperature and humidity in
an attempt to determine comfort level .
NOTE:
- Comfort indication can vary under the same temperature, depending on the humidity .
- There is no comfort indication when temperature is below 0°C (32°F) or over 60°C (140°F) .
" will keep flashing.
No signal
icon will show on the wireless sensor channels section of the
15
Alarm off
Weak signal
Too cold Comfortable
EN
Alarm on
Good signal
Too hot