First Steps; Assembly - BRAND Dispensette III Mode D'emploi

First Steps

Is everything in the package?
Confirm that your package includes:
Bottle-top dispenser Dispensette
valve and recirculation tube (optional), mounting tool, different bottle adapters, O-ring FKM (for autoclav-
ing), a performance certificate and this operating manual.
Nominal volume, ml
Dispensette III, Dispensette
®
0,5
1, 2, 5, 10
25, 50, 100
Dispensette HF
®
10

Assembly

Warning:
Wear protective clothing, eye protection and gloves! Follow all safety
instructions and observe limitations of use and operating limitations
(page 32-34).
1.
Check sealing
washer(s)
2.
Mounting the
SafetyPrime™
recirculation valve
(optional)
3.
Mounting the
Discharge tube
Note:
Recirculation valve and discharge tube must correspond to the model.
Pay attention to the color code. After two days tighten up the locking
nut.
38
, discharge tube, telescoping filling tube, SafetyPrime™ recirculation
®
Adapters for
bottle thread
Organic PP
®
24, 28, 33, 38 mm
28, 33, 38 mm
33, 38 mm
ETFE/ PTFE
33 mm (ETFE), S 40 mm (PTFE)
Before mounting the SafetyPrime™
recirculation valve or the discharge tue
make sure that the sealing washer is
inserted.
Push the SafetyPrime™ recirculation
valve approx. 2 mm into the discharge
tube and firmly finger-tighten the locking
nut (Fig. 2). Check the SafetyPrime™
recirculation valve for a tight fit.
Push the discharge tube (optional with
SafetyPrime™ recirculation valve, Fig.
3') approx. 2 mm into the valve block
and and firmly finger-tighten the locking
nut (Fig. 3). Check the discharge tube
for a tight fit.
Filling tube
Length, mm
125-240
125-240
170-330
125-240
1
2
3
3'